Download Print this page

Gainsborough K532 Assembly Instructions

Solar trickling water feature

Advertisement

Quick Links

Solar Trickling Water Feature
K532
v001: 28/03/22
Please read and retain these instructions for future reference
FOR OUTDOOR USE
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charged and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically.
To easily insert stakes into the ground, it is recommended to wet the ground first. To avoid damaging garden
stakes when inserting into the ground, select a spot in soft, rock-free soil. Insert the base of the stake first
then gently insert the rest of the stake into the base. DO NOT push directly against the solar cell or the
ornament housing containing the actual LED light.
Installation instructions:
1. Attach the pump to the solar panel before use, plug the sprinkler head or hose into the outlet of the
pump. Make sure the water level covers the pump, but is lower than the sprinkler head.
2. Plug the power line of the pump into the plug of the solar panel, and then fasten.
3. Position the solar panel in full sun to optimally run the pump, the backup battery will be charged from
the solar panel during normal operation and automatically run the pump without sunshine.
4. If required the pump can be run by the battery in times of low sunlight. Turn on the switch which is
located at the back of the solar panel. If the battery is fully charged the pump will start to work
immediately.
5. If the switch is turned off, the pump will be operated by the solar panel only.
The Enterprise
Department
Dimensions
(H) 41 x (W) 50x (D) 50cm
16V 10W SOLAR PANEL
12V 2.4W PUMP
THE SOLAR PANEL BE STAKED IN SUNLIGHT –
3M CABLE
ONE LED LIGHT
Max Flow Quantity of Pump: 400L/h
Max Water Height of Pump: 1.7m
Battery: 11.1V2200mAh Lithium battery
UK Head Office, 11 Bridge Street, Bishop's Stortford, CM23 2JU
Tel: 0844 4824400*,
Fax: 01279 756595
www.coopersofstortford.co.uk
EU address: D.S.B. LD, 160 Bd. de Fourmies, 59100 Roubaix, France
Tel: (+44) 1279 701269
*UK Calls cost around 7 pence per minute plus your telephone company's network access.
Please check with your telephone supplier.
ALWAYS POSITION IN DIRECT SUNLIGHT

Advertisement

loading

Summary of Contents for Gainsborough K532

  • Page 1 Solar Trickling Water Feature K532 v001: 28/03/22 Please read and retain these instructions for future reference ALWAYS POSITION IN DIRECT SUNLIGHT Dimensions (H) 41 x (W) 50x (D) 50cm • 16V 10W SOLAR PANEL • 12V 2.4W PUMP THE SOLAR PANEL BE STAKED IN SUNLIGHT –...
  • Page 2 Solar Trickling Water Feature Instructions for Use K532 Please read and retain these instructions for future reference v001: 28/03/22 Switch settings (Switch at the back of the solar panel) Care and Maintenance Recommendations 1. Clean solar panel with a soft sponge every couple of weeks.
  • Page 3 Solar Trickling Water Feature Instructions for Use K532 Please read and retain these instructions for future reference v001: 28/03/22 7. Make sure you clean the pump on a regularly bases when you are cleaning face the solar panel face down on a towel this will stop the pump running or switch it off.