Bosch WTU87RH1ES Installation And Operating Instructions Manual page 42

Home Connect
en
Set the programme to position 7.
1.
"Ÿ® (Energy manager) appears in
the display.
Press A.
2.
Your appliance now attempts to
connect to the smart energy system
(energy manager). If the appliance
has connected successfully, ™©Ÿ
appears in the display.
Activate Flexstart if you want the
3.
smart energy system (Energy
manager) to start up your appliance.
FlexStart
Activate the FlexStart function to allow
your smart energy system (Energy
manager) to start your appliance once
your home photovoltaic system is able
to provide sufficient energy or the
energy tariff is good.
Your smart energy system
Note:
(Energy manager) cannot start your
appliance until it is connected to the
appliance.
Activate FlexStart as follows:
Select the programme you require.
1.
Use the ˜ and ª selection buttons
2.
for the "Finished in" time to set the
required time.
Press A (Start/Pause).
3.
42
Press } (Remote Start).
4.
± appears in the display.
The FlexStart function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
If the time changes on the display to
ñ „.‹œ, for example, the smart energy
system (Energy manager) has
established a time at which your
appliance can start. The programme will
end after the specified time.
Notes
If the smart energy system (Energy
■
manager) does not start your
appliance, the programme will still
be started before the set time period
ends.
The programme will end when the
time period ends.
For safety reasons, } and in turn the
■
FlexStart function will be
deactivated in the following
circumstances:
– Press A.
– Open the door.
– Programme end.
– Press # to switch off the
appliance.
– Power failure.
If the FlexStart function is
deactivated, the ñ (ready in) will
remain active.
Adding more laundry or removing
laundry:
If the FlexStart function has
Note:
already been activated but the
programme has not yet started, you will
still be able to load more laundry or
remove some from the drum.
Press A (Start/Pause).
1.
Open the door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press A (Start/Pause).
5.
Press } (Remote Start).
6.