KI NGSL EY AS S EM BLY HAN DLE K IT
78
Note: Dimensions are nominal measurements only
Note : In wall n ot in cl u d e d i n ha nd l e k i t
Note: Di m en s i o n s are n o minal me asure me nt s o nly
SP ECIFICATIONS
RECOM MENDED USE
CO N STR UCTION
Disclaimer: Products in this manual must by law be installed by licensed and registered tradespeople in accordance with the relevant standards. ABI and the manufacturer/distributor reserve the right to
vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. The information listed is correct at the time of publication, however ABI and
the manufacturer/distributor takes no responsibility for printing errors. Copyright © ABI Interiors 2021.
14
Top View
25
54
Front View
D om e sti c
So li d B ras s
I NSTALLAT ION GUI DE
No te: This p rod uct must be insta lled by a licensed pl umb er.
Thi s is a general install atio n gui de - there are ma ny f act ors that are invo lved that ca n
alter the instal lati on method . This p rod uct install must comp ly with AS /NZS 35 00.
No te: In wa ll no t includ ed in ha ndle ki t.
New Build
- Install breach in desired position (please refer to additional install information regarding breach set backs).
Retrofitting Existing
-
Remove existing tapware & reseat body seats until shiny and smooth.
Remove locking nut from spindle. Screw spindle into breach and hand
1
tighten until rear of spindle meets the body seat, be sure not to overtighten.
If necessary apply more pressure lightly with spanner.
This product may require a bonnet extender (purchase at local hardware
3
store) that may be required to cover the additional breach depth. Please
refer to the following page for breach set back guide. If required, screw
bonnet extender on to locking nut.
Note: Bonnet extender
not included with assembly taps.
Available at local hardware store.
A 10mm brass spacer is provided to achieve optimum handle spacing
5
from the back plate. Insert spacer into rear side of handle and install
handle onto spindle, fixing with a screw and washer.
R e g u l a r l y c l e a n w i t h
m i l d l i q u i d d e t e rg e n t
o r s o a p a n d w a t e r
Fit the fibre washer over the spindle. Screw on the locking nut and
2
tighten with spanner. TEST AND CHECK FOR LEAKS.
Install the back plate onto the locking nut (or bonnet extender if
4
required), twisting by hand until tightened.
Insert handle cap into front of handle.
6
D O N OT u s e c re a m
D O N OT u s e c l e a n i n g
c l e a n e r s o r b l e a c h .
p a d s w i t h a b ra s i ve
T h e s e s u b s t a n c e s a re
s u r f a c e s a s t h i s m a y
a b ra s i ve
s c ra t c h t h e m a t e r i a l
Need help?
Do you have a question about the KINGSLEY 14629 and is the answer not in the manual?
Questions and answers