Ryobi PBLMS01 Operator's Manual page 16

TABLE EXTENSIONS
See Figures 13 - 15.
Table extensions have been provided for both the left and the
right side of the saw. The left and right extensions will only
fit properly one way. Be sure the front edge of the handle is
flush with the table.
To install table extensions:
 Align the lock nut inside the nut pocket located in the
underside of the base.
 While holding the lock nut in place, insert the bolt through
the extension and base, then thread into the lock nut. Use
the blade wrench to tighten the bolt into the lock nut.
NOTE: The left and right extension tables are different.
Be sure to check alignment to the front of the table before
installing bolts. Use a straight edge to check the exten-
sion table is level to the top of the base.
 Repeat for other side.
BOLT HOLE
LEFT TABLE
EXTENSION
BOLT
ASSEMBLY
LOCK
BASE
LOCK
NUT
Fig. 13
16 − English
SAW VIEWED
FROM BOTTOM
NUT
NUT
POCKET
Fig. 14
RIGHT TABLE
EXTENSION
BOLT
BASE
LOCK
NUT
Fig. 15