Compatibility Checklist - MAKESafe Tools PTC Series Manual

Getting Ready
This safety device is meant to be installed and used in conjunction with a power tool. Prior to
completing the compatibility checklist, collect the following items:
● The MAKESafe Power Tool Control.
● The power tool you intend to use with this product with.
● The instruction manual and specifications sheet for your power tool.
As the owner of this safety device and your pre-existing power tool, it is your responsibility to
complete this compatibility checklist before installing this safety device. If you cannot complete the
checklist, do not install the device.
Checklist
Confirm that the voltage, number of phases, and
❏
frequency of your power tool match the voltage,
number of phases, and frequency indicated on the
product.
❏ Confirm the motor horsepower on the power tool is
rated at or below the horsepower rating of your
product.
Confirm the power tool contains only a simple on/off
❏
switch and no other digital electronics, emergency
stop switches, reversing switches, or other motor
controls.
MAKESafe Tools, Inc. | Copyright 2021 | Last Updated 1/4/22

Compatibility Checklist

For More Information
This is typically marked on the motor
itself and on the top of the product.
This is typically marked on the motor
itself.
See section titled Recognizing
Existing Controls
Page 5