Using The Heater - HOMCOM 820-249V81 Assembly & Instruction Manual

EN

USING THE HEATER

HEATER OPERATION
Always operate the heater in the upright position following all instructions and
recommendations listed in this manual.
HEATER LOCATION
Place the heater in the area of the room that is coldest.
HEATER CONNECTION
Plug heater directly into 120 volt A.C. 60Hz outlet.Be sure the plug fits tightly in outlet.A
loose connection may cause overheating and damage to the plug or heater.
NOTE:To prevent overloading a circuit, do not plug the heater into a circuit that is serving
other electrical needs.
The heater may be operated by the controls located on the heater (see Fig.2) or by the
remote control(see Fig.3)
1. Carefully remove the heater from the plastic bag and the carton.
2. Place the heater on a firm level surface.
3.Power On the unit by switching on the Main Power Switch(Fig.1).The control panel will
show the current room temperature.
4.Turn the heater ON by pressing the on the control panel or remote control.
5.Press the button to force the heater to advance to LOW,HIGH or FAN mode.
6.To turn the heater off,press the POWER button.
NOTE: When the unit is powered off on the control panel, the fan may continue to run to cool
off the ceramic elements and dispense any retained heat.The unit shut off automatically
when sufficiently cooled down.
OSCILLATING FUNCTION
The Oscillating function will work in any mode.
1. Press the button to oscillate the heater fan from left to right across a wide degree
arc.To turn the oscillation off,press this button again.
TIMER FUNCTION
The Timer function will work in any mode.The timer function allows you to set the length of
operation from 1 to 8 hours.Each time the button is pressed the length of operation will
increase 1 hour.The duration the timer is set for will be displayed on the LED screen in hour
increments.TO TURN THE TIMER FUNCTION OFF: Press the button continuously until
the LED screen displays " 0 H"
3