Gainsborough K526 Assembly Instructions/Instructions For Use

Hanging Solar Lanterns Set 2
K526
v001: 08/12/21
Please read and retain these instructions for future reference
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Before using first time

CHARGING AND OPERATION:

1. Set button which is located on the solar panel to "ON"
position for charging and charge by placing it under direct
sunlight for at least 8 hours.
The light will work automatically. It will charge under direct
sunlight during the day time and illuminate at night.
NOTE: In order to verify that the button is correctly in the "ON "
position, cover the solar panel with your hand and light should
turn "ON" automatically.

IMPORTANT:

1. Place the item in an area where it can get direct sunlight.
2. Leave the button in the "ON" position.
3. Select an outdoor location away from other light sources at night, such as street lights. It may cause
the product not to turn on automatically at night.
4. Duration of light depends on solar product's level of sunshine exposure, geographical locations,
weather conditions and the hours of daylight.

MAINTENANCE AND TROUBLESHOOTING:

1. Make sure the switch is set to "ON" position.
2. Clean solar panel with a soft sponge every couple of weeks.
3. Make sure all connectors are still tight and no water getting in.
4. Battery 1x AAA 1.2v 300Mah, Ni-MH, Rechargeable, Non-replaceable.
Dimensions
(H) 29 x (W) 19 x (D) 17cm
•
SOLAR CUT OUT LANTERNS
•
1 X AAA 1.2V 300MAH NI-MH BATTERY (not replaceable)
•
CHARGING TIME 6 – 8 HOURS
•
SOLAR PANEL SPEC – AMORPHOUS SILICON 2V 45MA
•
19CM HIGH (EXCLUDING HANGER)
•
EACH LANTERN INCLUDES 1X WARM WHITE LED LIGHT (NOT
REPLACEABLE)
ALWAYS POSITION IN DIRECT SUNLIGHT
ON/OFF button