Machine Set-Up
STEP 1:
Install the GI-Series or GM-Series tape guides that
•
match the tape width you are going to use.
Push the screw through the Tape Guide and Guide
•
Bar and fasten with the wingnut on the back-side.
NOTE: Bias the holes/screws in the guides toward the
center of the machine.
Other notes:
• Be sure to install the tape guides at the correct width to tape
if you are going to be masking for a painted line.
• If you are only going to be taping using one roll of tape, be
sure to set up the tape guide as close to the center of the
machine as possible.
© 2022 Emery Game Line
Center of the
machine
Page: 3