FATEK P5150NH Installation Manual

Thank you for purchasing FATEK HMI. Before installing or operating the unit, please read
this installation guide carefully to ensure correct use.
1. Safety Precautions
1.1 General
 Unpack and check the delivery for transportation damage. If any damage or
deformation is found, please notify the supplier.
 The supplier is not responsible for the disassembled, altered or modified device.
 Never allow fluid or any conductive particles to enter into the HMI. Otherwise,
it may damage the HMI, cause fire or malfunction.
 Only qualified personnel may install the HMI, perform maintenance and
inspection.
 The liquid crystal inside the LCD panel is a hazardous substance. If the panel
is damaged, avoid contact with the leaked liquid crystal. If the liquid crystal
spills on clothing or skin, use soap and wash off thoroughly. In case of eye
contact the liquid, hold the eye open, flush with plenty water and get medical
attention as soon as possible.
 Do not touch any terminals while the power is on. Otherwise, it may cause
injury due to electrical shock.
 Disconnect the power supply before installing the HMI, do wiring operation,
perform maintenance or inspection. Otherwise, it may cause damage or
electrical shock.
1.2 Installation
 The installation may be carried out by qualified personnel only.
 Install the HMI according to the installation procedures.
 Check the power source voltage is within the specified range and the polarity
is correct before connecting the HMI.
 Keep signal and power supply cables away from high-voltage, large-current
carrying cables.
P5150NH HMI Installation Guide
(Read these precautions before use.)
1