Transport Precautions - Raider 549749 Original Instruction Manual

14 www.raider.bg
Important! Pull the charger plug directly off the hoverboard without tilting the plug / cable itself.
Allow the hoverboard time to cool after use and before charging.
Make sure the contact is dry.
Remove the rubber plug covering the socket, if any.
Connect the plug to the charger port and then plug the AC plug into a suitable outlet (230 Vac). If the red
indicator is lit, the Hoverboard is loading. If there is no indicator lamp, please check all connections.
When the red indicator light turns green, the hoverboard is fully charged.
Hoverboard charging time is between two and three hours.
Please keep clean and dry during charging.
Do not charge when the outlet is wet.
HIGH OR LOW TEMPERATURE BATTERY
If you want to make the hoverboard work efficiently, the battery temperature must be maintained within
the approved temperature range during charging.

TRANSPORT PRECAUTIONS

Lithium batteries are considered hazardous materials for transportation and you will need to obtain local
legislation. If you need to transport your lithium battery hoverboard, please contact the transport company
and ask them for their recommendations and policies.
BATTERY SPECIFICATIONS
Battery type
Charging time
Battery voltage / capacity
Work temperature
Charging temperature
Storage temperature
BATTERY REPLACEMENT
When it comes time to replace the battery, we recommend that you contact the nearest assistance point.
The battery used in your hoverboard is specially designed to meet the exact safety requirements and is
designed to work exclusively with your hoverboard. Using another battery is not recommended and may
increase the risk to your safety and the performance of your hoverboard.
CALIBRATION OF THE HOVERBOARD
Calibrating your hoverboard is part of the maintenance that needs to be done on a regular basis.
Recalibration will keep your hoverboard running smoothly. During prolonged use, your hoverboard may
become unstable or you will notice that one wheel rotates more than the other, this is natural and can be
easily corrected by recalibrating the hoverboard.
If your hoverboard feels unbalanced or the wheels cannot be synchronized, you need to perform a
calibration. This is easy if you follow the steps below:
1. Place your hoverboard on a flat surface.
2. Turn off the hoverboard.
3. Place the pedals parallel to each other.
4. Press and hold the ON / OFF button for about 10 seconds.
5. The hoverboard will start normally and after a few seconds will beep. Then the headlight will flash.
6. Turn the hoverboard off and on again.
7. The hoverboard is now ready for use.
If you have questions or ideas, please contact the nearest store.
MAINTENANCE AND STORAGE
DAILY MAINTENANCE
The hoverboard requires daily maintenance. Below is related to maintenance procedures and important
operating tips. Please make sure the power and charger are turned off before operating and performing
Li-ion
3-6 часа
36 V /2. 0 Ah
5-50 C
0
5-40 C
0
5-25 C
0