Facial Mist
Sprayer +
Skin Analyzer
A Closer Look
Water Tank
Mist Spray
Nozzle
Spray
Switch
Two - Way USB Ports
Water
Prongs
Percentage
Oil
Percentage
Digital
Skin Analyzer
Bottom of
Device
Charging / User Guide
BEFORE FIRST USE
NANO MISTER is cordless and
rechargeable. Before use, fully charge for 5
hours, even if the indicator light has
changed color. NANO MISTER can run up
to 10 hours on a single charge.
CHARGING
To recharge, insert the included USB Cord
into the port on the bottom of the NANO
MISTER. Connect the USB end of the
charging cord to a USB port of a
computer or a USB wall adapter and plug
into an electrical outlet. The indicator light will
be red while the device is charging, and will
turn green once fully charged.
USAGE TIME
Please keep in mind that the device can spray continuously for about
35 minutes when filled with water, and sprayed for 8-10 hours on a full
charge.
DIGITAL SKIN ANALYZER
Turn ON the digital skin analyzer by pressing the power button once.
The screen will glow a green light. Hold the prongs, located on the
bottom of the device, against the skin to be analyzed. You will hear a
beep when the process is complete. The number on top shows your
skins water percentage and the number below reads the skins oil
percentage. An emoji figure will showcase on the bottom right of the
screen to easily note the skins current hydration status. If the emoji
shows a sad face, use NANO MISTER by pressing the spray switch;
this will hydrate and balance the skin.
The Range for
The Range for
water is 0-99
oil is 0-19
The higher the water
percentage the better and in
the case of oil, less is more.
The goal is to be in the middle
of both ranges.
Skin is Hydrated
Skin is Dehydrated
Usage Guide
WATER TANK
Please note that the water tank should not be filled with any
macromolecule skincare product, such as essential oils, perfumes,
lotions or serums. Using these products will block the spray port and
affect the normal use of the machine. Please only use bottled distilled
or purified water to ensure no hard water build up clogs the nozzle of
the device.
READY TO USE:
Once you have assured of the full
charge of NANO MISTER, you can
proceed using your device.
SPRAY MODE:
Make sure the Spray Switch is lifted,
which is the OFF position. Gently twist
and lift the top off the NANO MISTER
to reveal the water tank. Fill the water
tank with 30 ml of water and twist the
top back on.
Hold the NANO MISTER 4-6 inches away from clean face or 8 inches
away if wearing makeup. Slide the spray switch down to begin
spraying. Lift the spray switch to the up position to stop spraying.
BATTERY BANK MODE:
The bottom of the NANO MISTER is equipped
with two-way USB sockets. The NANO MISTER
can be charged through the mini USB socket,
and the device can also be used to charge
other devices by simply using a USB cord to
plug the other device to the NANO MISTER.
NOTE: This product is powered by lithium
battery, and is not recommended to use
while it is being charged, as it will shorten the
battery life.
Need help?
Do you have a question about the NANO MISTER and is the answer not in the manual?
Questions and answers