Page 1
2. How to setup IPCorder in a few minutes • Install a SATA or SATA 2 hard drive into the IPCorder: Unscrew the back cover, attach the unplug-extender and plug disk into the IPCorder. Finally screw the cover back.
Page 2
IPCorder devices it can access. Discover In the case the utility fails to find your IPCorder, switch off your local personal firewall and/or antivirus. If the IPCorder is running in Rescue mode, you can change network settings by the button.
Page 3
For optimal function of IPCorder it s recommended to have latest stable version of firmware installed. Therefore before using IPCorder for the first time it is recommended to check if there is not any newer version of firmware available. The description is available in the under section.
Page 4
FDDShow filter itself can be downloaded for example from 5. Support Should you experience any issues with IPCorder, you can report them at (available in English only). We take all suggestions seriously, and consider all ideas for improvements in our future releases.
Need help?
Do you have a question about the KNR-200 and is the answer not in the manual?
Questions and answers