Aux Operations - Clarion MAX685BT Owner's Manual & Installation Manual

AUX Operations

This function is available when a VTR, etc. is connected to the AUX terminal.
• For your safety, the driver should not watch the video or operate the controls while driving.
Please note that watching and operating the video while driving are prohibited by law in
some countries.
Note:
• For your safety, this system has a safety function which turns off the picture when the car is moving, so only
the audio can be heard. The picture can only be watched when the car is stopped and the parking brake is
applied.
• When an iPod with video is connected using the special connector cable (CCA-723) separately sold, the
video/audio input from the iPod will be output to the monitor screen and rear monitor even in the AUX mode.
However, you must select the iPod mode to control the iPod.
Selecting the AUX mode
1. Press the [SRC] button, and touch the [AUX]
key.
Showing the AUX mode screen
The AUX mode screen is used to adjust settings
concerning the AUX mode.
1. Touch the screen.
The AUX mode screen is displayed.
If you do not touch the screen for 7 seconds,
the display will return to the video screen.
Changing the audio input level
The input audio level of the AUX terminals can be
changed.
• The factory default setting is "HIGH".
1. Touch the screen to display the AUX mode
screen, then repeat touching the [SENS] key
to select the level.
HIGH: 10 dB
MID: 4 dB
LOW: 0 dB
WARNING
Selecting the screen size
You can change the screen size to suit to the
video image.
• The factory default setting is "F.Wide".
1. Touch the screen to display the AUX mode
screen.
2. Repeat touching the [F.Wide/Cinema/
Normal/Wide] key until your desired screen
size is selected.
• This key shows the current screen size
setting.
[F.Wide]:
The image is expanded so that the rectangle
of the image fits to the screen (16:9). The
aspect ratio of the image may be changed.
[Cinema]:
The image is expanded so that the top and
bottom edges of the image fit to the screen.
[Normal]:
The image is expanded so that the top and
bottom edges of the image fit to the screen,
and that the aspect ratio of the image
becomes 4:3. The aspect ratio of the image
may be changed.
[Wide]:
The image is expanded in the same way as
the [F.Wide] setting, but the width will become
narrower. Depending on the image data,
black areas may be displayed at the both
sides of the screen.
3. Touch the [Hide] key to return to the video
screen.
57
MAX685BT