Advertisement
Connecting the USB device to USB IN Jack on the TV
Connect the USB device to USB IN (or USB IN SERVICE ONLY) Jack on the TV
※ Position of USB In Jack : Side or Rear (differ depending on your TV Model)
Running the software upgrade
If TV recognize the latest software for customer's TV model from connected USB device,
it will appear below message.
Please select "start" to execute the upgrade automatically
※ If there are the same or lower software version in the USB device than Software version in your TV,
doesn't appear below message.
※ A few USB devices may not be compatible with the TV, in that case you use another USB device.
Warning!!
!
Please don't disconnect the power or remove the USB device while running the upgrade.
!
Note
You can check the upgraded software version on the "Diagnostics menu"
( OSD Menu: Setup -> Diagnostics)
It might be initialized previous menu setting (Channel tuning, Picture, Audio,,,)
If you have still problem after upgrade, please contact with us again.
OR
Step1. Please select "Start" to execute the upgrade automatically.
- Press Arrow key to move to the "Start"
Step2. Copying software file from the USB device to the TV
※Don't remove the USB device while this message is displayed.
Step3. Running the software upgrade
※ Don't turn off the power while this message is displayed.
※ If some problems happen during upgrade,
the TV will display the error message and
restart to return to the previous version.
Step4. Complete the software upgrade
- If the upgrade is completed, this message is displayed.
- The TV will turn off and on automatically after the upgrade completed.
Advertisement
