SmartDHOME WBSH1-7 Manual

SmartDHOME WBSH1-7 Manual

Electric charging station

Advertisement

Quick Links

Electric charging station WBSH1-7
User manual and data sheet
Thank you for choosing the SmartDHOME electric vehicle charging station. Below are all the technical specifications and
procedures for correct installation.
www.myvirtuosohome.com
www.smartdhome.com
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WBSH1-7 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SmartDHOME WBSH1-7

  • Page 1 Electric charging station WBSH1-7 User manual and data sheet Thank you for choosing the SmartDHOME electric vehicle charging station. Below are all the technical specifications and procedures for correct installation. www.myvirtuosohome.com www.smartdhome.com...
  • Page 2 Electric charging station WBSH1-7 User manual and data sheet Abbreviations and Safety Notes Abbreviation Description International Electrotechnical Commission Electrical Vehicle, this can be BEV (battery EV) or PHEV (plug-in hybrid EV) EVSE Electric Vehicle Supply Equipment (IEC61851-1) On-board charger (of an EV)
  • Page 3: Warning Signs

    Electric charging station WBSH1-7 User manual and data sheet The following warning signs, mandatory signs and information signs are used in the WBSH1-7 charging station. Warning signs ATTENTION: Warning of electrical hazards. This signal is intended to alert the user that if the device is not used correctly, serious personal injury or extensive property damage may occur.
  • Page 4: Operation

    Do not leave flammable or explosive substances near the charging station, in order to avoid serious damage to things and / or people. • The WBSH1-7 charging station must be installed in a place free of dust, gases or vapors harmful to insulation. •...
  • Page 5 Electric charging station WBSH1-7 User manual and data sheet • At any time, in the event of an emergency (such as fire, smoke, anomalous sounds, water leakage, etc.) it is possible to press the emergency button in order to interrupt the recharge cycle and send the "Stop"...
  • Page 6: Data Sheet

    IEC 62196-2 Description and Data Sheet The WBSH1-7 charging station is ideal for charging electric vehicles and can be installed in residential environments, hotel parking, garages and car parks. For a correct installation please carefully follow the following manual. Data Sheet...
  • Page 7: Charge Control

    Electric charging station WBSH1-7 User manual and data sheet Circuit Input circuit terminals L1 – N – PE Charging method 3 modes Charge control Light indicators 4 LEDs (Indicate four states: power, charge, fault and network) • Ethernet (RJ-45 interface) •...
  • Page 8: Package Contents

    Electric charging station WBSH1-7 User manual and data sheet Package Contents • Charging station for electric vehicles • Wall mounting accessories: • 2 RFID cards...
  • Page 9: Pre-Installation

    The front panel of the product cannot be subjected to stress. • In order to ensure a long life of the WBSH1-7 charging station, it is recommended not to install the charging station in environments subject to high temperatures which could limit the life and cause structural changes to the product.
  • Page 10: Installation

    Electric charging station WBSH1-7 User manual and data sheet • It is recommended to install the charging station in a place with good ventilation, without direct sunlight and sheltered from wind and rain. • To ensure good ventilation, mount the charging station vertically and leave enough space.
  • Page 11 Electric charging station WBSH1-7 User manual and data sheet • As shown in the figure below, unscrew the four screws to open the terminal covers [A]. Then continue with the wiring. Terminal covers Grommet of the input cable Charging cable...
  • Page 12: Rs-485 (Modbus)

    RS-485 (ModBus) The WBSH1-7 recharging station has the ModBus communication protocol, of the RS-485 type; all the steps for a correct configuration are shown below.
  • Page 13 After completing the connection and installation of the WBSH1-7 charging station, it can be started. The LED it will light up and it will mean that the station has passed into the Stand-by state. As shown in the figure, the WBSH1-7 charging...
  • Page 14 Electric charging station WBSH1-7 User manual and data sheet [A] LED The four LEDs arranged on the main panel indicate the status of: power, charge, fault and network. [B] Magnetic card area In the area dedicated to the magnetic card it is possible to swipe the smart card provided and start the recharging cycle.
  • Page 15: Parameter Configuration

    NOTE! To complete the configuration procedure correctly, the charging station and the smartphone must be in the same coverage area as the router. Parameter configuration Note: The WBSH1-7 charging station can be configured using a laptop or smartphone connected to the Internet. For a correct configuration follow all the steps below. •...
  • Page 16 Electric charging station WBSH1-7 User manual and data sheet • Enter the password 12345678 to access the configuration menu. It is advisable to change the password once logged in. • After modifying the parameters, click “SAVE” to save all the data correctly. Then click “RESTART” to restart the recharging station and make all the changes made active.
  • Page 17: Start Charging

    Electric charging station WBSH1-7 User manual and data sheet Start charging To correctly start the charging of your vehicle it is advisable to follow all the steps indicated below: • Park your electric car, turn it off and put it in parking mode.
  • Page 18: Emergency Button

    Once you have finished charging your electric vehicle, please manually remove the station socket from the electric car and place it in the side socket of the charging station. Management Errors The WBSH1-7 electric vehicle charging station is equipped with automatic fault protection. The error handling table is shown below. Information on the...
  • Page 19 Electric charging station WBSH1-7 User manual and data sheet then three times quickly. correctly. • Check the input voltage. • Check that the incoming cables are connected Flashes once slowly and Overvoltage correctly. then four times quickly. • Check the input voltage.
  • Page 20: Maintenance

    Electric charging station WBSH1-7 User manual and data sheet quickly. recommend that you contact our customer support through the following link: http://helpdesk.smartdhome.com/users/register.aspx The RCD protection is damaged and requires the assistance Flashes twice slowly of one of our specialized technicians, therefore we...
  • Page 21: Warranty And Customer Support

    Electric charging station WBSH1-7 User manual and data sheet Warranty and customer support Visit our website: http://www.ecodhome.com/acquista/garanzia-eriparazioni.html If you encounter technical problems or malfunctions, visit the site: http://helpdesk.smartdhome.com/users/register.aspx After a short registration you can open a ticket online, also attaching images. One of our technicians will answer you as soon as possible.

Table of Contents