Name Of Items; Installation; Operation - HOMCOM 800-127V90 User Manual

III. NAME OF ITEMS
IV. INSTALLATION
The freezer should be placed on a flat and solid-top surface. lt should be kept away
from sunlight, heat source, humid or mess place. The freezer should be kept away
from the wall for a proper space for good air circulation. When the freezer is placed in
a cupboard, the rear of the cupboard must be removed out for good circulation.
V. OPERATION
1.Before the freezer is plugged in, check the following:
-There must not be any damage on all electrical wire.
-Earthing screw must be well fixed.
-Wall outlet must be properly earthed.
Be sure that everything is in normal condition and the freezer can be plugged in.
2.When operating for the first time
When operating is in normal condition and the freezer without any load until it auto
stops at the desired temperature, usually it takes 2 or 3 hours. Then set the
thermostat to the required setting and place foods in.
3.Temperature control
Freezer's temperature can be adjusted by turning the knob of the thermostat that
at the rear of unit. The closer to "5" position the knob is set, the lower the
temperature becomes. A medium setting is the most suitable for general
operation. The position "5"is cooler than the position "1".Freezerstemperature will
vary depending on the quantity of foods stored and the frequency of the door
opening. In order to maintain good cooling efficiency and save energy, We
recommend you not to store too much foods and not to open the door too
frequently. And you can turn to "0", the unit will stop working.
CAUTION: When the thermostat has been turned clockwise to "5"position, do not
attempt to turn it more over. Otherwise it will be damaged.
4