Page 1
Operation and Maintenance Guide 4 V M 4 VM SG Iron and Stainless Steel Construction, All variants Models Descriptions FOOT Model with Lube / Lube-Free, SG Iron / SS & NPT / BSPT 4VMSXXX Variants FACE Model with Lube / Lube-Free, SG Iron / SS & NPT / BSPT 4VMLXXX Variants NEMA Model with Lube / Lube-Free, SG Iron / SS &...
Operation and Maintenance Guide 4 VM Air Motor Series Page 2 Table of Contents Nomenclature Technical Data Safety Instructions Installation Instructions Operating instructions Suggested Lubricants Troubleshooting Dis assembly and Re-assembly Exploded View for 4VM Air Motor Bill of Materials for 4VM Series (SG Iron) Bill of Materials for 4VM Series (SS) Dimensional Data Repair Kits for 4VM Performance Eu Declaration Of Conformity Warranty Certificate FF-MM-369-REV - 02...
Operation and Maintenance Guide 4 VM Air Motor Series Page 3 Nomenclature Material of Lubricated or Threading on Inlet Size Motor Type Mounting Construc- Lube-Free and Outlet tion L - Face Type VM - Vane Type S- Foot Type A- Lubricated R- NPT PM - Piston Type L - SG Iron...
Do Not temp. Class T6 (85°C). dis-assemble in explosive atmosphere. Caution i. EN / ISO 80079-36 : 2016 : Explosive Use only genuine Teryair or Teryair approved atmospheres—Part 36 :Non-electrical accessories. equipment for explosive atmospheres— Basic metod and requirements...
Operation and Maintenance Guide 4 VM Air Motor Series Page 5 Safety wear mandatory while operating Vane should not exceed 80º C. Do not continue motor to operate the motor if the measured surface temperature exceeds temperature listed on the Air stream from product may contain solid o motor.
Lube-free. Hoses • Daily before operation check the hoses, especially the high pressure hoses for damage or leaks • Use genuine Teryair spares and if possible mention the serial number of the Vane motor when ordering spares. FF-MM-369-REV - 02...
Operation and Maintenance Guide 4 VM Air Motor Series Page 7 Suggested Lubricants Brand Above 27 Deg C ( From 5 Deg C to 27 Deg C Below 5 Deg C Shell Toona R 72 Toona R 41 Toona R 27 Mobil Almo 529 Almo 527...
Operation and Maintenance Guide 4 VM Air Motor Series Page 8 Dis assembly and Re-assembly Disconnect air supply and vent all air lines. fall during assembly). Now place the 4 Air stream from product may contain solid or nos. Rotor Blades (16) into the rotor shaft liquid material that can result in eye or skin grooves.
Operation and Maintenance Guide 4 VM Air Motor Series Page 10 Bill of Materials for 4VM Series (SG Iron) Illu. Part Description FACE FOOT NEMA Number 4VMLAL 4VMLOL 4VMSAL 4VMSOL 4VMDAL 4VMDOL 4VMNAL 4VMNOL HOUSING-NPT 804 05 01 HOUSING -NPT (LUBE-FREE) 804 05 01LF HOUSING-BSPT 804 05 11...
Operation and Maintenance Guide 4 VM Air Motor Series Page 11 Bill of Materials for 4VM Series (SS) Illu. Part Description FACE FOOT NEMA Number 4VMLAS 4VMLOS 4VMSAS 4VMSOS 4VMDAS 4VMDOS 4VMNAS 4VMNOS HOUSING-NPT 804 07 01 HOUSING -NPT (LUBE-FREE) 804 07 01LF HOUSING-BSPT 804 07 06...
Operation and Maintenance Guide 4 VM Air Motor Series Page 14 Repair Kits for 4VM Repair KIT Ordering No Suitable for 8049701 Suitable for 4 FACE / FOOT VM variant 8049702 Suitable for 4 VM IEC / NEMA variant Note - Repair Kit includes Blades, Bearings, Shims, Blade springs, Oil Seals and O rings FF-MM-369-REV - 02...
Page 15
Notified body to whom Technical file has logged with: - Technicka Inspekcia (Ref: 1354). DECLARATION: - TERYAIR EQUIPMENT PVT. LTD., declare that under our sole responsibility for the supply of the product defined above, the said product complies with all the applicable Directives, Regulations and all essential Health and Safety requirements applying to it.
Teryair; (vii) the issue with a Product is directly or indirectly attributable to, or directly or indirectly results from or arises out of, compliance with any design, specification or other specific requirement of Dealer/End User;...
Page 17
Operation and Maintenance Guide 4 VM Air Motor Series Page 17 This page is intentionally Left blank. FF-MM-369-REV - 02...
Need help?
Do you have a question about the 4 VM Series and is the answer not in the manual?
Questions and answers