Remote Start ", Page - Siemens SN63H800UE Instructions For Use Manual

Basic setting
InfoLight
Tone volume
Wi-Fi
Remote Start
Factory setting
1
Factory setting (may vary according to model)
Display text Selection
1
I01 I00 - I01
1
b02 b00 - b03
Cn0 Cn0 - Cn1
rc1 rc0 - rc2
rE Start with
YES
Confirm with
Basic settings en
Description
Switch InfoLight on or off.
While the programme is running, a
spot of light is projected onto the
floor below the appliance door. This
light will not be visible if the appli-
ance is installed at eye level with the
cabinet front fitted flush. If the appli-
ance door is not completely closed,
the spot of light will flash. The pro-
gramme has ended when the spot of
light is no longer visible on the floor.
Level "I00" switches InfoLightoff.
Adjustment of tone volume.
Level "b00" switches the signal tone
off.
Switch the wireless network connec-
tion on or off.
Level "Cn0" switches the wireless
network connection off.
The basic setting "Wi-Fi" is only avail-
able once the appliance is connec-
ted to the Home Connect app.
→ "Home Connect ", Page 36
Activate or deactivate
→ "Remote Start ", Page 37.
The following settings are possible:
¡ With the setting "rc0", the func-
tion is permanently deactivated.
¡ With the setting "rc1", the func-
tion can be selected via the
button.
→ "Activating Remote Start ",
Page 37
¡ With the setting "rc2", the func-
tion is permanently activated.
This basic setting is not available un-
til after you have connected the
device with the Home Connect app.
→ "Home Connect ", Page 36
Restore changed settings to the fact-
ory settings.
The settings for initial start-up must
be configured.
35