Summary of Contents for In-Ex 300
- Page 1 OWNER’S MANUAL FOR THE Spreader 300 In-Ex™ P O Box 1010, 145 Harts Road Palmerston North Ph: 06 354 6060 Fax: 06 355 3199 E-Mail: sales@c-dax.co.nz...
-
Page 2: Safety Precautions
YOUR SAFETY IS IN-EX’s PRIMARY CONCERN ▪ It is important that you understand that any loads or attachments whether fastened to or placed on a vehicle or ATV will alter the stability and handling characteristics of that vehicle or ATV. -
Page 3: Table Of Contents
IN-EX Spreader 300 OWNER’S MANUAL (Pt.No.2400-6950 Issue 5, August 2022) TABLE OF CONTENTS Safety Precautions Table of Contents Description Specifications Order Information Warranty Operation Calibration Operating the Spreader Adjusting the Spread Pattern Fitting the Rain Cover Maintenance Before Use After Each Use or Daily when in Use... -
Page 4: Description
DESCRIPTION The IN-EX Spreader 300 is a ground-driven spreader designed for application of pelleted fertilisers. It can also be used for application of other products such as grass seed and magnesium oxide. The uniquely designed 300-litre translucent non-corrosive polyethylene hopper is specially profiled for good product flow and ease of filling. - Page 5 C-Dax will at its option repair or replace the defective equipment (or part of the equipment) or notify the retailer of the equipment to refund the purchase price for such defective equipment to you in the event of a breach of this warranty, subject to the terms set out below. Liability Except for the warranty set out in clause 1.2 above, all warranties and representations (including those expressed or implied by law) in respect of the equipment or advice relating to...
-
Page 6: Operation
OPERATION The product to be spread is placed in the hopper. When the spreader is towed forward, the right hand wheel drives through the pin clutch and gearbox to turn the spinner in a clockwise direction. When the shutter handle is pulled forward, the shutter at the bottom of the hopper rotates to an open position. -
Page 7: Operating The Spreader
Calibration Guide (Average Speed 10 Kph) Rate Shutter Setting Nominal Spread Product (Kg/ha) (Lever Position) (Metres) Urea or DAP Urea or DAP Urea or DAP Super phosphate 30% Potassic Super Rye Grass Magnesium Oxide Magnesium Oxide powder is applied at a rate determined by the number of cows to be treated. When spreading this product, calculate the weight of powder to be applied and apply this amount using shutter setting 4 or 5. -
Page 8: Fitting The Rain Cover
Fitting the Rain Cover To fit the rain cover to the hopper, loop one corner of the cover over a corner of the hopper then stretch the cover over the opposite corner of the hopper so that the elastic edge holds it in place. Then stretch the third corner over the hopper rim followed by the last corner. -
Page 9: Parts Diagram
PARTS DIAGRAM... -
Page 10: Parts List
Spinner-Mount-CDIT300/400/INEX300-ZP 1036-8240 Agitator-Spreader-CDIT300/400-In-Ex300/400-SS 7500-2120 Rota-Hopper-Spreader 300 -Natural-MDPE-In-Ex 9200-8900 Wheel-Turf-Keyed-18x950x8-4 Ply 9200-8700 Wheel-Turf-Bearing-18x950x8-4 Ply 7500-2795 Rota-Spout-Spreader-165/300/400-Natural-MDPE 2150-0025 Collar-Shaft-ID25-ZP 2250-7940 Cover-Shaft-Drive Axle-77mm Long-Spreader 300-PVC 2840-1120 Fastener-Bolt&Nut-Hex-8.8 Grade-M10x120-ZP 6500-8950 Profiled-Vane-Spinner-Spreader-CDIT300/400-Galv 8200-2100 Spinner-Disc-CDIT300/400/1300 5050-7940 Linkage-Shutter-In-Ex Spreader 300-ZP 3230-0008 Fastener-Retainer Cap-Starlock-8mm-Nickle Plated 6500-7770 Profiled-Shutter-CDIT300/400 4050-1600... - Page 11 6100-4860 Pin-Locking-8x57mm-ZP 2890-0812 Fastener-Cap Head-Allen-Screw-12.9 Grade-M8x12-Black 2810-0860 Fastener-Bolt&Nut-Hex-304 Grade-M8x60-Stainless 3310-6008 Fastener-Washer-Flat-M8-ZP 3310-2809 Fastener-Washer-Flat-M8x22x1.5-Grade 316-Stainless 5245-3905 Mount-Handle-Spreader 300-ZP 3290-1275 Fastener-Set Screw-Hex-8.8 Grade-M12x75-ZP 2250-4100 Cover-Hopper-Silver Fabric-Spreader CDIT300...