Download Print this page

Lippert Sirio 2.0 PVC Oem Installation Manual

Sirio 2.0 PVC Blinds

OEM INSTALLATION MANUAL

Table of Contents

Need help?

Do you have a question about the Sirio 2.0 PVC and is the answer not in the manual?

Page 1 Sirio 2.0 PVC Blinds OEM INSTALLATION MANUAL...
Page 2 Notes Introduction The Sirio 2.0 PVC blind assembly is a combination of a flyscreen and shade for windows that can be pulled up or down by hand using the two different profiles. The integrated spring shaft tensions the fabric permanently and gives optimum hold. The entire assembly is simply hung on the inside wall window console and secured.
Page 3 Moving parts can pinch, crush or cut. Keep clear and use caution. Resources Required • Cordless or electric drill or screw gun • Appropriate drive bits • (4) #6 x 1/2" screws Installation Located on the inside wall of the unit, place the Sirio blind assembly (Fig. 1A) over the window and center.
Page 4 Operation There are two different window profiles: blind (Fig. 5A) and screen (Fig. 5B). Place your hand in the middle of the lower profile (Fig. 5B) to raise or lower the Sirio flyscreen (Fig. 6) slowly. Place your hand on the middle top profile (Fig. 5A) to raise or lower the Sirio blind (Fig. 7) slowly. Both profiles can be in use at the same time as well.
Page 5 Notes Page 5 Rev: 06.29.22 CCD-0006411...
Page 6 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (LCI). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...