Sealey HT300R Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
1.1. GENERAL SAFETY
8
DO NOT shine directly into your, another person's or an animal's eyes.
8
DO NOT allow children to use the torch.
8
DO NOT use the torch if you suspect that the battery or the torch casing is damaged.
8
DO NOT leave batteries in a discharged state. Before storage remove batteries and dispose of in the correct manner.
1.2. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
‰
8
DO NOT attempt to open the battery.
DO NOT crush, puncture, short contacts or dispose of in fire or water.
8
8
DO NOT expose to temperatures above 60°C (140°F).
9
If the electrolyte in the batteries gets on your skin, thoroughly rinse with water. If it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
2. INTRODUCTION
3W COB + 1W SMD Rechargeable headlight with sensor function. Also including 3 SMD LED's producing 300 Lumens. Can also act as a
separate mini worklight with magnet. 3.7V 1000mAh Li-Poly battery with 0.5m USB cable included. Charging and battery indicator capabilities.
4hr maximum runtime using COB.
3. SPECIFICATION
MODEL NO: ............................................................ HT300R
Battery: .................................. 3.7V 1000mAh Li-Poly Battery
Charging Time: ...............................................................3-4hr
LED Qty: ..........................................................1 COB 3 SMD
LED Type: .......................................................... COB + SMD
Lumen Output: .................................COB-150lm SMD-300lm
Operating Time: ........................................ COB/SMD 4hr/2hr
4. OPERATION
4.1. TORCH OPERATION
Press power button (fig.1) once to turn unit on.
4.1.1.
The battery charge state is indicated by the 4 blue LEDs (fig.1).
4.1.2.
Press power button again to light the primary light (fig.1).
4.1.3.
4.1.4. Press power button again to also light the secondary
light (fig.1).
Press the power button again to turn the unit off.
4.1.5.
4.2. LIGHT SENSOR
Press the sensor button (fig.1) to enable sensing.
4.2.1.
4.2.2. Pass hand in-front of light until light comes on.
Pass hand in-front of light again and light goes off.
4.2.3.
Press the sensor button (fig.1) to disable sensing.
4.2.4.
4.3. TILTING HEAD
4.3.1. The headtorch has 4 possible lockable positions, 0
20 0 , 40 0 , and 60 0 .
4.4. DISMOUNT TORCH
4.4.1. Twist the light unit through 45
headband mounting.
4.4.2.
© Jack Sealey Limited
3W COB & 1W SMD LED RECHARGEABLE
HEADLIGHT WITH SENSOR
HT300R
MODEL NO:
Sensor Button
Battery
State
Indicators
0 ,
0 to remove it from
Original Language Version
Power Button
Light Sensor
Secondary
Light
SMD
fig.1
HT300R Issue 2 (2) 04/07/22