Sealey HT106LED.V2 Instruction Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Refer to
instruction
manual
1.1. GENERAL
WARNING! Disconnect lamp from mains power before performing any maintenance.

DO NOT shine lamp directly into your, other person's or animal's eyes.

DO NOT allow children to use the lamp unsupervised.

Maintain the lamp in good condition.

DO NOT use the lamp if the lamp if damaged.

1.2. ELECTRICAL SAFETY FOR USE OF TRANSFORMER. USE ONLY THE SUPPLIED TRANSFORMER PLUG FOR CONNECTING
LAMP TO THE POWER SUPPLY.
WARNING! It is the user's responsibility to read, understand and comply with the following electrical instructions:

You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices. An RCCB (Residual Current
Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD (Residual Current Device) is
used with all electrical products, particularly portable equipment which is plugged into an electrical supply not protected by an RCCB.
You must also read and understand the following instructions concerning electrical safety.
1.2.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.2.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
Inspect the transformer plug, cable and connector for wear and damage to ensure items are safe before connecting to the mains

power supply. If worn or damaged DO NOT use.
Important: Check that the voltage marked on the transformer plug is the same as the power supply to be used.

Uncoil the cable between transformer plug and lamp.

DO NOT pull the transformer plug from the mains socket by the lead.

DO NOT use any other type of transformer with this product.

DO NOT try to take the transformer plug apart.

DO NOT use the transformer plug to power any other electrical item.

DO NOT get the transformer plug wet, or use in wet, damp conditions (for indoor use only).

WARNING! NEVER substitute a standard 13amp 3 pin plug, or any other type of plug, for the transformer plug.

This transformer plug reduces and rectifies the mains voltage (230 volts AC) to 3.7V DC.
fig.1
© Jack Sealey Limited
INSTRUCTION MANUAL FOR:
CORDLESS HEAD TORCH 3W CREE LED AUTO
SENSOR RECHARGEABLE
HT106LED.V2
MODEL NO :
Original Language Version
HT106LED.V2 Issue: 1 - 29/03/16