Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Alu-Cab A-RT-TBL
Summary of Contents for Alu-Cab A-RT-TBL
- Page 1 Drop Down Table GEN3/3.1/3R Tent...
-
Page 2: Components Supplied
Tools & Items Required: TOOLS 10mm Ring Spanner Drill Bit Ø5mm (Gen3/3.1 only) #4 Allen Key/Socket #10 Allen Key/Socket Pop-rivet gun (Gen3/3.1 only) COMPONENTS SUPPLIED 4 X ASL 4.8x 21 large flange rivets 1 X R-TA-TBL-A00 (GEN3R TABLE ASSY) 4 X M5x12 COUTERSINK BOLT 4 X M5 FLAT WASHER 4 X M5 NUTCAPS 4 X M5 NYLOCS... - Page 3 STEP 1 To adjust the distance of the mounting brackets of the Drop Down Table, first measure the distance between the two outer fasteners on the Shoe bag.
- Page 4 Step 2 To adjust the mounting brackets, loosen the nut and bolt combinations at the bottom of the assembly at the slots. Adjust the brackets to the length measured in ‘Step 1’, then fasten the nut and bolt combinations.
- Page 5 Step 3 Remove the 4 outer fasteners on the Shoe bag.
- Page 6 Step 4 Align the mounting holes on the brackets with the mounting holes of the fasteners that were removed. Mount the Drop Down Table by re-fastening the bolts that were removed.
- Page 7 NB: If you have a Gen3 or 3.1 tent you will have rivets instead of riv-nuts. So we have supplied 4 off 4.8x21mm large flange rivets so you can drill the corner rivets out and pop the brackets into place. If you have bolts and the thread is spoilt, then you can use the rivets to replace the bolts as well.
- Page 8 Closing the table To fix the table in the closed position, flip the table top up and fix it in position by turning the lockstay over the tabletop.
- Page 11 The finished fitment should resemble the images below:...
Need help?
Do you have a question about the A-RT-TBL and is the answer not in the manual?
Questions and answers