Venus CVN95 Quick Start Manual

Venus CVN95
Particulate respirator N95 ­
1. Failure to follow all instructions and limitations concerning the use of the respirator
and/or failure to wear the respirator for the whole duration of exposure to contaminants
can seriously reduce the performance characteristics of the respirator and lead to
illness, injury or death.
2. ­ Before occupational use, the wearer must be trained by the employer in the correct use
of the respirator in accordance with applicable safety and health standards.
3. OSHA standards including 29CFR1910.134 (e) (5) and CSA standard Z 94.4-93
require that the wearer be fit-tested.
4. Discard the respirator and replace with a new one if:
Excessive clogging of the respirator causes breathing difficulty
The respirator becomes damaged. ­
Discard the respirator and replace with a new one after every use. ­
5. Leave the contaminated area if dizziness, irritation or other distress occurs.
Contaminants or their concentration are unknown or immediately dangerous to life or
health.
Construction of contaminants exceed maximum use constructions in applicable
OSHA standards or applicable government regulations or 10 times the PEL
(Permissible Exposure Limit), whichever is lower.
For sandblasting, paint-spray operations, asbestos.
2. Do NOT modify or misuse the respirator.
3. Do NOT use the respirator with beard or other facial hairs that interferes with direct
contact between the face and the edge of the respirator, or any other conditions
that may prevent a good face-seal.
"A" Series respirators should be replaced when the wearer senses an increase
in breathing resistance due to the filters collecting particulate matter. Replace mask
frequently.
A
Do NOT use
For protection against hazardous concentration of gases or vapor
For sand-blasting, paint-spray operations, asbestos