Advertisement
INSTRUCTIONS FOR USE:
Recharging The Battery
Your Watertight Jumpstart Kit comes complete with a built-in lead acid battery.
Fully charge before first use.
To Recharge Using The 120V AC Power Cord:
Plug one end of the AC charging cord into the Charging Port of the Jumpstart
System. Plug the other end into any standard 120 volt wall outlet. The red
Charging LED Indicator will illuminate to show that the unit is charging. Full
charging will take approximately 20 hours.
To Recharge Using The 12V DC Power Cord:
Plug one end of the 12V DC power cord into the Charging Port of the Jumpstart
System. Plug the other end into your craft's cigarette lighter socket or 12 volt DC
power port. The red Charging LED Indicator will illuminate to show that the unit is
charging. Full charging will take approximately 11 hours.
Note: Some cigarette lighters/12 volt power ports will not operate unless the
ignition switch is in the accessory position.
Note: Never attempt to continuously recharge the unit for more than 36 hours.
Use only the AC and DC recharging cords that were provided with the unit or
permanent damage to the unit may result.
Checking Battery Status
➄
Press and hold down the battery level button
. The battery level indicator LEDs
will light up to show the level of charge remaining in the unit. When you release
the battery level button, the battery level indicator LEDs will switch off.
When all three LEDs light up, the battery is FULLY charged.
When the amber and red LEDs light up, the battery is 50% charged.
When only the red LED lights up, you must recharge the system before using again.
Advertisement
