Assembly Instructions - Vivanco WMS 751 PL S Assembly Instructions Manual

WMS 751 PL S / WMS 451 PL S Assembly instructions
WMS 751 PL S Suitable for plasma screens with a diameter between 34" and 63" (86 cm - 160 cm)
WMS 451 PL S Suitable for plasma screens with a diameter between 22" and 34" (56 cm - 86 cm)
Congratulations! You have made a good decision by purchasing a Vivanco wall mount.
Please keep these instructions for later use.
The products are designed to be used in private homes.
Correct assembly is essential for the long life and functionality of your wall mount.
Please observe the following points carefully:
Technical data:
· Maximum load bearing:
WMS 751 PL S 75 kg
WMS 451 PL S 45 kg
· Adjustable by 15º up and down.
· Adjustment mechanism with allows adjustment of the screen angle without tools.
Notes on safety:
· The mount is intended for fixing to the wall only.
· Before attaching the mount check it thoroughly for any damage.
· Never use defective parts.
Please observe the following before assembly:
· It is expressly recommended to have installation carried out by a specialist.
· Make sure that the quality of the wall is sufficient to hold the weight of the screen plus that of
the mount – the screws could come loose.
bearing of the wall, please consult a specialist from the building trade.
· The fixing materials must be suitable for the type of wall (material, thickness, condition), so that the
maximum load bearing of the wall can be guaranteed. For this reason no fixing materials have been
included with your wall mount. Please ask a specialist, giving the relevant details.
· Also make sure that there are no electricity cables or gas/water pipes in the wall.
· Before assembling, check the location of the nearest mains socket.
· Use a spirit level when attaching the wall mount. Crooked attachment will reduce stability.
WMS 751 PL S/WMS
If there is any doubt regarding the condition and load
6
451 PL S