Advertisement
Roadside Mailboxes – 4325
2-Wide Spreader with Newspaper Holders
on a Pedestal Installation Instructions
Installing Mailboxes on 2-Wide Spreader with
Newspaper Holders on a Pedestal
Thank
you for selecting Salsbury's 4325 roadside mailbox.
This instruction sheet is for installing 4325 mailboxes on a 2-wide spreader
with 4315 newspaper holders and a pedestal. A different instruction sheet is
available for installing 4325 mailboxes on a 3-wide or 4-wide spreader with
4315 newspaper holders and a pedestal. Other installation instructions are
available for installing the mailbox on a pedestal, or on a deluxe mailbox
post, installing the mailbox on a spreader, and installing the pedestal in a
concrete footing.
When you install a curbside or roadside mailbox, make sure that it is easily
accessible to the mail carrier. By regulation a locked mailbox should be 41"
to 45" from the ground or street surface up to the point of mail entry. The
door should be set back 6" to 8" back from the front face of the curb or the
road edge. However, you should check with your local postmaster to ensure
that the mailbox is installed according to local regulations. It is important to
note that it is not the responsibility of mail carriers to open mailboxes that are
locked, accept keys for this purpose, or lock mailboxes after delivery of the
mail.
Spreader Installation to Pedestal
All hardware to attach the spreader to the pedestal is included with the
spreader. To attach the spreader to the pedestal, install four (4) 5/16"-18 X
1" long hex flange head bolts through the four (4) center square holes of the
spreader and through the four (4) tapped holes on the top plate of the
pedestal. Cover the hex flange head bolts with cap plugs.
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
SALSBURY INDUSTRIES
nd
1010 East 62
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269
Fax: 1-800-624-5299
www.mailboxes.com
Copyright © 2014 Salsbury Industries. All rights reserved. (Rev. 01, 2/19/14)
Newspaper Holders Installation to Pedestal
All hardware to attach the newspaper holders to the spreader is included with
the spreader. To attach a newspaper holder to the spreader, install four (4)
5/16"-18 x 1-3/4" long carriage bolts through the four (4) square holes in the
inside floor of the newspaper holder and through the four (4) corresponding
holes on the spreader. Install 5/16" flat washers and 5/16"-18 hex nuts on
the ends of the four (4) bolts protruding below the bottom of the spreader.
Repeat these steps for the other newspaper holder.
Mailbox Installation to Newspaper Holders
All hardware to attach the mailboxes to the newspaper holders is included
with the newspaper holders. To attach a mailbox to a newspaper holder,
install four (4) 5/16"-18 X 3/4" long carriage bolts into (4) square holes in the
floor of the mailbox and through the four (4) square holes on the top of the
newspaper holder. Install 5/16" flat washers and 5/16"-18 hex nuts on the
ends of the four (4) bolts protruding below the top of the newspaper holder.
Cover the hex nuts with cap plugs. Repeat these steps for the other mailbox.
Installation is now complete. Additional hardware provided is not needed
and may be discarded.
Int'l Phone: 323-846-6700
Int'l Fax: 323-846-6800
engineering
mailboxes.com
@
U.S.P.S. APPROVED
Advertisement
