Advertisement
Wearing the TWS: Quality of Fit and Cable Slack
• TWS prototype should be worn properly to ensure a
high-quality VA signal.
• Make sure the TWS fits tightly inside the ear.
• If the fit is too loose, use a larger rubber eartip .
• If the TWS mockup has cables, follow these steps:
1. Make sure that there is slack in the cables.
• Cables connected to TWS should be loose (not pulling tight)
• Use tape to secure cable and reduce tension. This also reduces cable
fluttering during wind testing.
2. Place the interface board near the wearer
• The interface board (connected to the TWS with cables) should not
be too far. It could be on a nearby table, or strapped to the shoulder.
7
Vesper - Confidential
Advertisement
