Page 1
OWNER’S MANUAL BBQ KITCHEN WITH SINK AND STORAGE MGKITSS6FR USE OUTDOORS ONLY PLEASE READ INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY RETAIN THIS MANUAL FOR FUTURE REFERENCE...
CONTENTS Important Safety Information General Information for Successful Assembly Product Diagram Parts list Assembly Instructions Connecting the Gas Cylinder Gas Supply Information Connecting the Gas Bottle to the Appliance Checking for leaks Lighting Instructions Main Burner Safely using your BBQ Flare-up Control Fat Fires Cleaning and Care...
IMPORTANT SAFETY INFORMATION Please read this user manual before using this BBQ and keep it safe for future reference. Read the following instructions carefully this appliance the cylinder may tend to ⚫ and be sure your BBQ is properly installed, freeze and supply gas at reduced pressures assembled and cared for.
ASSEMBLY INSTRUCTIONS Install the side handle and tap using 2 x M6x16 bolts. The tap can be connected to a hose pipe adaptor. Insert the drainage tube (12) into the sink hole. Install the side handle of the fridge using 2 x M6x16 bolts.
Page 6
Using the two the back panels (10) secure each side of the unit using 8 x M6x16 bolts. Attach the flame tamer to the unit as shown. Gently insert the cooking grid and cooking plate.
Put the warming rack onto the unit. Finally connect the gas bottle and your BBQ will be ready to use. For fridge installation and use, please see the fridge user manual insert. CONNECTING THE GAS CYLINDER GAS SUPPLY information This appliance is only suitable for use with low pressure Butane, Propane, or LPG mixtures, fitted with the appropriate low-pressure regulator via a flexible hose.
Page 8
REGULATOR AND HOSE • This BBQ is provided with a 27mm clip on 37 mbar regulator, suitable for Calor Patio gas, Flogas Leisure gas, BP Gaslight and similar. • Replacement regulators are available from your equipment retailer or an authorised bottled gas stockist.
CONNECTING THE GAS BOTTLE TO THE APPLIANCE • Before connecting the gas supply, ensure that there is no debris caught in the head of the gas cylinder, regulator, burner or burner parts. Spiders and insects can nest within and clog the burner/ venturi tube at the orifice.
LIGHTING INSTRUCTIONS If any burner fails to ignite after a number of attempts, turn the control dial to the off position (clockwise) and also turn the cylinder valve off. Wait for five minutes before attempting to light the BBQ again. MAIN BURNERS 1.
SAFELY USING YOUR BBQ FLARE-UP CONTROL Flare-ups can occur during barbequing, and is caused by fat and juices falling onto a hot surface. Avoid excessive flare-ups to prevent food from being burnt. The flame tamers are designed to help limit the amount of flare ups, but these must be kept in good condition and free of grease to be effective.
When the appliance is not in use for a period of time it should be carefully packed for storage and stored in a dry, dust free environment. A cover is available to buy separately from your Monster Grill stockist, order code BBQCK2.
TECHNICAL INFORMATION TROUBLESHOOTING POSSIBLE CAUSE SOLUTION PROBLEM 1. LP gas cylinder is empty Burners will not 1. Replace with full cylinder 2. Faulty regulator light using the 2. Have regulator checked or replace 3. Obstruction in burner ignition system 3. Clean burner 4.
MANUFACTURER SUPPORT 0333 305 2261 Office hours: 9AM - 5PM Monday to Friday Monster grill Unit J6, Lowfields Business Park Lowfields Way, Elland West Yorkshire, HX5 9DA...