Page 2
2 Hz Unit is in locate mode. network with a DHCP server, use the HBM Device EXRCPU Quick Start Guide coil the cable in a loop. Manager (on the included USB drive) or contact your IT RUN (yellow) administrator to find out the IP address.
Page 3
EXRCPU Quick Start Guide Adding an EXRCPU to eDAQ layers 3. Make sure each layer is set with a unique address using appropriate jumpers. Make sure jumper addresses ascend from low to high (1, 2, 3...) under the EXRCPU (C). The layer with the lowest address (1) is the greatest distance from the EXRCPU. The interface for installing an EXRCPU on eDAQ layers (1-EXR-E-ADT-2) (B) (including six (6) 30mm screws) may be purchased Install the eDAQ layers on the top of the stack using six (6) screws each.