Siemens Gigaset USB Stick 108 Manual page 48

Problem
The data transfer
rate seems too low
The Gigaset USB
Stick 108 does not
work properly
XR mode does not
work
All measures had
no effect
Causes and remedies
ì
If possible, position your PC with the Gigaset USB Stick 108
closer to the Access Point or remove any visible obstacles.
ì
Re-align the aerials of the Access Point.
ì
Change the transfer rate from AUTO to a fixed value if
necessary.
ì
Change the transmission mode of the Gigaset USB Stick 108
to 802.11g if necessary.
ì
Try another channel. Make sure that the channel setting is
changed on the Access Point first.
You have checked all of the causes specified above, and still no
communication is possible.
ì
Uninstall the software and install it again as described in the
chapters "Deinstalling the Gigaset USB Stick 108" on
page 35 and "Installing the Gigaset USB Stick 108" on
page 7.
This functionality will become available with the new software
to be launched around September 2005. Download the new
software from the Siemens website (see below), if necessary.
It is possible that there is a fault in the software. Check our
website at www.siemens.com/gigasetusbstick108 to see if a
newer version of the software is available. Proceed as has been
described in the chapter "Updating device drivers" on page 36.
Appendix
47