Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Elsner KNX T-UP
Summary of Contents for Elsner KNX T-UP
- Page 1 KNX T-UP Temperature Sensor Technical specifications and installation instructions Elsner Elektronik GmbH Control and Automation Engineering Herdweg 7 D – 75391 Gechingen Phone +49 (0) 70 56 / 93 97-0 info@elsner-elektronik.de Germany +49 (0) 70 56 / 93 97-20 www.elsner-elektronik.de...
- Page 2 • Socket Ø 60 mm, 42 mm deep • Frame (for element 55 x 55 mm), suitable for the switching programme used in the building Temperature Sensor KNX T-UP • Date of issue: 06.04.2011 • Technical changes reserved. Errors reserved.
- Page 3 EN 60730-1:2000 Section EMV (23, 26, H23, H26) • EN 50090-2-2:1996-11 + A1:2002-01 • EN 61000-6-1:2004 The product has been tested for the above mentioned standards by an accredited EMV laboratory. Temperature Sensor KNX T-UP • Date of issue: 06.04.2011 • Technical changes reserved. Errors reserved.
- Page 4 Temperature variations from such sources of interference must be corrected in the ETS in order to ensure the specified accuracy of the sensor (temperature offset). Temperature Sensor KNX T-UP • Date of issue: 06.04.2011 • Technical changes reserved. Errors reserved.
- Page 5 Then screw the base plate onto the socket and position the frame of the switching pro- gramme. Connect the bus line +/- (black-red plug) to the terminals provided on the sen- Temperature Sensor KNX T-UP • Date of issue: 06.04.2011 • Technical changes reserved. Errors reserved.
- Page 6 After the bus voltage has been applied, the device will enter an initialisation phase las- ting 5 seconds. During this phase no information can be received via the bus. Temperature Sensor KNX T-UP • Date of issue: 06.04.2011 • Technical changes reserved. Errors reserved.
Need help?
Do you have a question about the KNX T-UP and is the answer not in the manual?
Questions and answers