Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Elsner KNX T-AP
Summary of Contents for Elsner KNX T-AP
-
Page 1: Temperature Sensor
KNX T-AP Temperature Sensor Technical specifications and installation instructions Elsner Elektronik GmbH Control and Automation Engineering Herdweg 7 D – 75391 Gechingen Phone +49 (0) 70 56 / 93 97-0 info@elsner-elektronik.de Germany +49 (0) 70 56 / 93 97-20 www.elsner-elektronik.de... -
Page 2: Technical Specifications
5.5 mA, max. 15 mA when programming LED is active Data output KNX +/- bus terminal plug BCU type Own micro controller PEI type Group addresses max. 184 Allocations max. 184 Communication objects Temperature Sensor KNX T-AP • Date of issue: 29.03.2012 • Technical changes reserved. Errors reserved. - Page 3 The device must only be operated as stationary system, i.e. only in a fitted state and after completion of all installation and start-up works, and only in the environment in- tended for this purpose. Temperature Sensor KNX T-AP • Date of issue: 29.03.2012 • Technical changes reserved. Errors reserved.
- Page 4 The sensor must be mounted vertically. The measurement probe and the cable outlet must point downwards. Temperature Sensor KNX T-AP • Date of issue: 29.03.2012 • Technical changes reserved. Errors reserved.
- Page 5 After the bus voltage has been applied, the device will enter an initialisation phase las- ting 5 seconds. During this phase no information can be received via the bus. Temperature Sensor KNX T-AP • Date of issue: 29.03.2012 • Technical changes reserved. Errors reserved.
- Page 6 As a precaution, the device should always be separated from bus current for maintenance works. Temperature Sensor KNX T-AP • Date of issue: 29.03.2012 • Technical changes reserved. Errors reserved.
Need help?
Do you have a question about the KNX T-AP and is the answer not in the manual?
Questions and answers