Assembly & Operating Instructions - Nesco FG-600 Care/Use Manual

Assembly & Operating Instructions
1. Place the unit on a flat and stable work
surface and insert the grinding head into
the base. Figure 1
2. Lock the grinding head into place using
the head lock/release lever. Figure 2
3. Insert the auger into the grinding head,
the drive end first. Figure 3
4. Place the cutting blade onto the auger
shaft. (The cutting edges should face the
cutting disc). Make sure blade is seated over
'square' shoulder of auger or the meat will
not grind properly. Figure 4
5. Place the grinding plate onto the auger
shaft. (Make sure the notches of the
grinding disc fit into the projections of the
grinding head). Figure 5
6. Turn the ring nut on the grinding head and
tighten securely. Figure 6
7. Place the hopper into the barrel of
grinding head.
8. Make sure the power dial is in the "OFF"
position and insert plug into 120 volt
electrical outlet.
9. Place a wide, shallow bowl or plate
beneath the grinding head to catch
ground food.
10. Turn the dial to the "1" position for first
grind. Always have the unit running
before adding food. Turn the dial to the "2"
position for second grind.
11. Place food into the hopper and use the food
pusher to gently feed food into the auger.
Do not force food into the grinder head and
NEVER use fingers or tools not recommended
by the appliance manufacturer to feed food
into the grinder head. Figure 7
IMPORTANT! NEVER PUT YOUR FINGERS
INTO THE FOOD HOPPER OPENING WHILE
UNIT IS ASSEMBLED.
12. When you have finished grinding food,
turn the power dial to "OFF" and unplug
from the electrical outlet.
1
2
3
4
5
6
7
4