Table of Contents
Advertisement
8. CHANGING BITS/SCREW DRIVER BITS (see fig. d)
Inserting:
♦ Insert the bit into the tool holder.
Removal:
♦ Pull the bit out of the tool holder.
Replacing the cutting blade (see fig. e + f)
Note:
Before carrying out any work on the appliance, ensure that the rotation direction switch is in the middle.
This prevents unintentional switching on.
Start by connecting the cutting attachment to the appliance. This blocks the motor spindle and allows
the screw to be removed.
Unscrew the screw (I).
Remove the cutting blade (II) by pulling it downwards.
Push in a new cutting blade (II) from below ensuring that the ground edge of the blade faces you. Turn
around the blade (II) until it fits onto the tool fitting (III).
Tighten the screw (I).
The attachment can now be used again.
CAUTION!
► There is an arrow (
running direction of the cutting blade.
9. OPERATION
9.1) Switching the cordless screwdriver ON/OFF
Switching on:
To start the appliance, press the ON/OFF switch and keep it pressed in.
Switching off:
Release the ON/OFF switch to switch off the appliance.
9.2) Changing the direction of rotation
Clockwise:
Push the rotation direction switch to the left.
Press the ON/OFF switch, the clockwise rotation; you can now screw in the screws.
Anti-clockwise:
Push the rotation direction switch to the right.
Press the ON/OFF switch, the anticlockwise rotation; you can now unscrew the screws.
Safety lock-out:
Push the rotation direction switch into the middle position. The ON/OFF switch is blocked.
Note
When the ON/OFF switch is locked it is still possible to activate the LED lamps. To do this, press the
ON/OFF switch.
9.3) Tips and tricks
Screw bits are labeled according to their dimensions and their shape. If you are unsure, always try the
particular screw bit out to see whether it sits in the screw head without any free play.
) on the blade guard of the cutting attachment. This shows you the recommended
10
ORIGINAL INSTRUCTIONS>EN
Advertisement
Table of Contents
