Control 4 C4-DIN-8REL-E-V2 Wiring Manual

8-Channel Relay
Wiring Guide

Supported model

• C4-DIN-8REL-E-V2 8-Channel Relay

Diagrams color code*:

Black Line
Red Load
Grey Neutral
Green Earth ground
Blue Ethernet
*Important! The wire colors shown in Figures 1 and 2 and in the
"Diagrams color code" table are examples only. Actual wire colors differ
by country and/or voltage.

Wiring diagrams

Use these Control4 8-Channel Relay wiring diagrams along with the 8-Channel
Relay Installation Guide ( ctrl4.co/8chrelay-ig ) to install 8-Channel Relays.

Figure 1. Wiring in Control4 panel

Override switch
Distribution
(breaker)
panel
Load 1
Load 2
Line 1
Load 3
Load 4
Line 2
Load 5
Load 6
Line 3
Load 7
Load 8
Line 4
Aux Override In
Aux Override Out
Neutral Out 1
Neutral Out 2
Neutral In 1
Neutral Out 3
Neutral Out 4
Neutral In 2
Neutral Out 5
Neutral Out 6
Neutral In 3
Neutral Out 7
Neutral Out 8
Neutral In 4
Ground
Only Load 1 shown in detail
All Line-Ins MUST be the same phase
Important: Remove the four bypass
jumpers that connect each black
terminal to two red terminals by
unscrewing all three screws in each
bypass jumper until the entire bypass
jumper can be pulled out.
Terminal block
Load 1
Load 2
Neutral 1
Line 1
Load 3
Load 4
Neutral 2
Line 2
Load 5
Load 6
Neutral 3
Line 3
Load 7
Load 8
Neutral 4
Line 4
Aux in
Aux out