Led Pattern; Troubleshooting; Switch Function - Mitsubishi Electric MAC-558IF-E Installation Manual

6. LED pattern

:ON :OFF :Flashing
Description
Power is ON or software downloaded
ALL settings reset
WPS activated (PBC)
WPS activated (PIN)
WPS enabled
WPS failed
Server and access point communication connected, and air
conditioner communication failed
Server and access point communication connected, and air
conditioner communication connected
Server and access point communication connected, and air
conditioner communication starting up
Server communication failed, and air conditioner communication
connected
Server communication or access point communication failed, and
air conditioner communication starting up
Server communication or access point communication failed, and
air conditioner communication failed
Access point communication failed, and
air conditioner communication connected
Access point communication failed, and
air conditioner communication starting up

7. Troubleshooting

If at any stage you see the
orange LED 2 light up, this is an
indication that there is a problem
with the router communicating
with the adaptor.
If you are still experiencing issues connecting your router to the Wi-Fi adaptor then please contact our
helpline on 0800 639 434.

8. Switch Function

(1) WPS switch
The WPS switch is used for pairing the Wi-Fi adaptor with the access point. There are two types of WPS:
push button configuration (WPS-Push) and PIN code method (WPS-PIN).
• WPS-Push
Hold down the WPS switch for 2 seconds to start WPS-Push pairing.
When WPS-Push is enabled on the Wi-Fi adaptor, LED1 starts flashing green (0.5-sec interval) and the
pairing can be completed by enabling WPS-Push on the access point.
• WPS-PIN
Hold down the WPS switch for 15 seconds to starts WPS-PIN pairing. When WPS-PIN is enabled on
the Wi-Fi adaptor, LED1 starts flashing green (0.2-sec interval) and the pairing can be completed by
enabling WPS-PIN on the access point.
Before using WPS-PIN, the PIN code of the Wi-Fi adaptor needs to be set on the access point.
This product is only compatible with the access point that supports WPS.
(2) RESET switch
• Hold down the RESET switch for 2 seconds to reboot the system.
• Hold down the RESET switch for 15 seconds to initialize the Wi-Fi adaptor to the factory default.
When the Wi-Fi adaptor is reset to the factory default, ALL the configuration information will be lost.
Take great care in implementing this operation.
LED1
(0.5-sec interval)
(0.5-sec interval)
(0.2-sec interval)
(once every 5 sec)
(once every 5 sec)
(once every 5 sec)
If this occurs, you may need to check the following:
• WPS is working on your router
• Signal is reaching the adaptor
• DHCP addresses are available
• Your router is compatible with the adaptor - for a list of
compatible routers, see www.mitsubishi-electric.co.nz/wifi
LED2
(0.5-sec interval)
(5-sec)
(5 sec)
(0.5-sec interval)
(0.5-sec interval)
(0.5-sec interval)
(0.5-sec interval)
LED3
(0.5-sec interval)
(once every 5 sec)
(once every 5 sec)
(once every 5 sec)
11