Contents Your dishwasher ........................Important safety instructions ....................General ............................Child safety ..........................Installation ..........................Winter storage/transport ......................Overflow guard function ......................Packing material ........................Disposal ............................ Before washing for the first time ................... Water hardness ......................... Set the Rinse aid ........................Top up with rinse aid ........................
Page 3
Remove blockages ........................Troubleshooting ........................Installation instructions ......................Important safety instructions ....................Setup ............................Drain connection ........................Connection to water supply ...................... Electrical connection ......................... Service ............................. Technical information ......................Technical data ...........................
Your dishwasher Main power switch Display Install the dishwasher, see the chapter Installation instructions. Following this, open the door and press the main power switch to start using the machine. The first time the dishwasher is switched on, it is important that you choose the right settings to ensure good dishwashing results.
Important safety instructions SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE WARNING! When using your dishwasher, follow basic precautions, including the following: Read all instructions before using the dishwasher. Use the dishwasher only for its intended function. Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children.
Child safety Always keep small children away from the machine when it is open. There may be some detergent residue left inside the machine. Always close the door and start the dishwasher as soon as you put in the detergent. If dishwasher detergent gets in someone’s eyes, rinse them with plenty of water for at least 15 minutes.
Before washing for the first time Water hardness In order to achieve good dishwashing results, the dishwasher needs soft water (water with low mineral content). Hard water leaves a white coating on dishes and the dishwasher. Checking water hardness Contact the local water utility to check the water hardness in your area. This is important to determine how much detergent and rinse aid to use.
Greener dishwashing The dishwasher saves energy and water When using a dishwasher in a residential setting, less energy and water are generally used compared to washing the dishes by hand. Do not rinse under running water Do not rinse the dishes under running water as this will lead to increased energy and water consumption. Simply scrape off large food particles before loading the dishwasher.
Loading the dishwasher Fragile dishes Some cookware is not dishwasher safe. This can be for several reasons. Some materials cannot withstand high temperatures, others can be damaged by dishwasher detergent. Use caution with, for example, handmade items, fragile decoration, crystal/glassware, silver, copper, tin, aluminum, wood, and plastic.
Upper basket Place glasses, cups, bowls, side plates, and saucers in the upper basket. Place all soiled surfaces face down! Place wine glasses on the wine glass shelf. Place knives in the knife stand on the right (if space allows). Raising and lowering the upper basket 1.
Lower basket Place plates, side plates, serving dishes, and pots in the lower basket. Foldable tines Fold down the foldable tines when washing pots. Release the foldable tines by pressing the catch inward before adjusting their position. Typical load Recommended for daily, regular, or typical use. Upper basket NOTE! Ensure the upper basket is set to its lowest position.
Using the dishwasher Add detergent 1. Prewash detergent compartment Press to open 2. Main wash detergent compartment Detergent is added according to water hardness. Follow the instructions on the detergent packaging. Too much detergent can result in less effective dishwashing and also entails greater environmental impact.
PROGRAM - Select program Press the desired program until the program symbol is activated. Auto Wash The dishwasher can measure how dirty the dishes are and adjust water consumption and temperature accordingly. When newly installed, the program needs to be run five times before it is fully adapted and can provide the best results.
- Select option To select an option, press one of the option buttons until the option is activated. The available options vary between programs and some options cannot be combined (available options glow dimly). SpeedWash This option shortens the program time, but uses more energy and water. Auto open The dishwasher door opens automatically, which improves the drying results.
- Time remaining Once you have chosen a program and options, the time the program took when last used is displayed. Status light The status light on the bottom part of the dishwasher indicates that a program has started. Flashing light A flashing light indicates that the door has been opened while a program is in progress.
How to get the best drying results Fully load the dishwasher. Angle dishes with hollows, such as cups, so that the rinse water will run off. This is also important for plastic items. Top up with rinse aid or increase the rinse aid dosage level. Activate the Auto open option.
Settings Open the settings menu: First, open the door. Turn off the machine. Press and hold the main power switch until the display lights up. The display shows the settings menu (current setting and its currently set value). (Exit the menu by browsing through the menu or pressing the main power switch.) Navigate the settings menu: Press to save the setting value and continue to the next Press to browse between setting values.
Care and maintenance instructions Top up with rinse aid When the rinse aid needs topping up, the above symbol lights on the display. After topping up, it may take a while before the symbol goes out. Press to open 1. Open the rinse aid compartment lid. 2.
1. Turn the locking ring counterclockwise and lift the fine filter straight up. 2. Clean the fine filter. 3. Refit the fine filter and turn the locking ring clockwise to its stop position. Check that the edges seal properly. Remember to refit the coarse filter! NOTE! Dishwashing results may be affected if the coarse and fine filters are incorrectly fitted.
Upper spray arm 1. Pull out the upper basket. 2. Unscrew the spray arm bearings counterclockwise to remove the spray arm from the upper basket. Clean the dishwasher inside and out Door and door seal Open the door. Clean the sides of the door and the door seal regularly with a slightly damp cloth. Clean the door seal at the lower front edge of the dishwasher with a washing-up brush.
Page 23
Drain pump stop 5. Turn the pump wheel located behind the drain pump stop by hand. Carefully remove any items. 6. Reinstall the drain pump stop along with the fine and coarse filters. 7. Plug the machine in again. If the dishwasher still does not start and a humming sound is heard, the overflow protection has been triggered.
Troubleshooting Type of fault on the display Action Overfilling Clear the drain pump. See the chapter Care and maintenance in- structions. If the problem persists, call the Customer Care Center. Water outlet fault See “Water remains in the dishwasher above the filters” in the table “Problem”...
Page 25
Problem Possible causes Action The dishwasher does not start. The door is not closed properly Close the door within four sec- or was not closed immediately onds, otherwise the dishwasher after starting the program. will not start. See Starting the dishwasher in the chapter Using the dishwasher.
Page 26
Problem Possible causes Action Detergent is too old. Detergent Avoid large packages. is a perishable product. Dishes loaded incorrectly. Do not cover dishes with large bowls or lids. Avoid placing very tall glasses in the corners of the baskets. Glasses and cups have toppled Load the dishes securely.
Page 27
Problem Possible causes Action "STR" is shown on the display. The dishwasher door has been If you want the dishwashing opened while a program is in program to continue, press any progress. button and close the door within five seconds. If you want to cancel the dish- washing program, press and hold the main power switch until...
Page 28
Problem Possible causes Action Low temperature programs Run a program with a higher have been selected for a pro- temperature about once a longed period. month. Or select the self-clean- ing program. See Self Clean in the chapter Using the dishwash- Grease deposits in the dish- Low temperature programs Select a program with a high...
Installation instructions Inches (mm) Door length Nominal dimensions. Actual measurements may vary. It is important that you read through and follow the instructions and directions below. Conduct installation and connection in accordance with the separate installation instructions. Important safety instructions Connections to electricity, water, and drainage must be performed by a qualified professional.
Inches (mm) The electrical and water supplies should enter through the area indicated by the shading on the illustration. Make sure the area on which the dishwasher is to be installed is firm. Adjust the adjustable feet so that the dishwasher is level. If the dishwasher is built-in, the surrounding furnishings must be resistant to any condensation from the dishwasher.
Connection to water supply Use only the inlet hose supplied with the dishwasher. Do not re-use old or other spare hoses. The supply pipe must be fitted with a water supply valve. The water supply valve must be easily accessible, so that the water can be shut off if the dishwasher has to be moved. Once the installation is complete, turn on the water supply valve and allow the pressure to settle for a while.
Service Read the chapter Troubleshooting before contacting the Customer Care Center. If you have encountered a problem that you cannot resolve, please contact your nearest Customer Care Center for professional help. When making contact, provide the details on the serial number plate. Include the article number (1) and the serial number (2).
Technical information Technical data Model designation: LUDWT30250 Height: 33.74-36.61″ (857-930 mm) Width: 23.94″ (608 mm) Depth: 21.82″ (554.3 mm) Weight: 80 lb (36 kg) Water pressure: 4.2-140 psi (0.03-1.0 MPa) Electrical connection: See serial number plate Rated power: See serial number plate...
Page 34
862219-a2 We reserve the right to make changes.
Need help?
Do you have a question about the LUDWT30250 and is the answer not in the manual?
Questions and answers