GLOBIZ 55069C Quick Start Manual

55069C – Reversing camera built into the license plate frame - 12V
Replace your conventional license plate holder with a version that includes a camera. You can
easily insert the cables for the license plate light. The vertical tilt of the camera can be
adjusted over a wide range.

Easy to install

Compatible with all cars

Adjustable camera

Wide angle view

Built-in 4pcs LED

RCA signal cable connecting to the display (the display is not part of the set!)
Power source:
Camera viewing angle: 170°
Resolution:
Set includes:
Size:
Signal cable length:
Color:
Material:
Protection:
Warnings:
- The surface of the sensor must be kept clean!
- When reversing, always check the environment, look around and use the rear-view mirrors!
- Reverse at low speed to react to unexpected situations!
- Have the appliance installed by a specialist!
- Disconnect the cable from the battery (+) terminal before installation.
Wiring:
1. Connect the wires with the red connector to the reversing lamp connector and provide
adequate insulation.
2. Connect the black cable to a ground cable or a point on the car body.
3. Use the yellow RCA cable to transmit the video signal to the display.
4. You can mount the camera in place of a standard-sized license plate frame.
5. After mounting, place the license plate in the frame by inserting the upper edge of the
license plate from below under the camera bracket. (We recommend using double-sided
adhesive on the back of the license plate if required)
12V
648 x 488 px
1 pc license plate frame
1 pc reversing camera
1 pc set of cables
545 x 140 x 35 mm
6 m
Black
Plastic
IP67