Related Manuals for JCM Load Monitoring ALRS2
Summary of Contents for JCM Load Monitoring ALRS2
- Page 1 ALRS2 USER INSTRUCTIONS ALRS2 USER INSTRUCTIONS Software Version 2.1.0 P a g e V e r s i o n J C M - A L R S 2 - V 4...
-
Page 2: Table Of Contents
ALRS2 USER INSTRUCTIONS TABLE OF CONTENTS: PAGE NO SYSTEM DESCRIPTION Page 3 TURN ON LINK Page 4 SWITCHING THE HANDSET ON Page 4 ZERO AND TARE Page 4 DISPLAY UNIT / UNITS OF MEASUREMENT Page 5 POWER SAVING Page 5... -
Page 3: System Description
The load cell is turned on via a switch on the load link and the monitoring system is switched on via the power button on the ALRS2 handset. This is to save battery during long term out of use. The load cell can be left switched on and can then be switched on/off from the ALRS2 handset. -
Page 4: Turn On Link
When you switch the handset on it will also wake up the transmit board to start transmitting. To switch the ALRS2 electronics on press the power button this will switch on both the transmit board inside the load cell and the handset. -
Page 5: Display Unit / Units Of Measurement
ALRS2 USER INSTRUCTIONS The ALRS2 system will not allow you to zero more than 4% of the WLL of your load cell. This is due to safety reasons to ensure that large loads are not accidentally zeroed from the display. -
Page 6: Lcd Contrast
Peak The ALRS2 handset constantly displays the peak on the display. If you wish to zero the peak displayed press the peak button. You will then have the option to enter either no or yes. Press the up and down arrow until your selection is highlighted then press the OK button. -
Page 7: Channel Reset
ALRS2 USER INSTRUCTIONS Channel Reset If your handset ever displays the message ‘Connecting’, firstly change the batteries in both the handset. If the handset still displays connecting you will have to perform a Channel Reset. Enter the menu and select Channel Reset on page two of the menu. Select the Yes option by moving the cursor over Yes and press enter. -
Page 8: Icon Identification
Will display when the unit is transmitting to JCM Load Logger ALRS2 channel number Each ALRS2 system transmit the data via a dedicated channel number. The channel will be required for logging. Unit of measurement indication. This can be changed using the Unit Config option in the ALRS2 handset menu. -
Page 9: Trouble Shooting
Signal Strength not When the batteries in the handset are running low, to conserve battery displaying the ALRS2 system will disable the signal strength icon. Replace the batteries and the signal strength shall display. Handset makes 2 beep This indicates that your handset is resetting its channel number to audible noises ensure continuous communication.