The electricity connection Serial Number ......................must be made by a qualified specialist. Installation must Register your product www.linarie.com.au comply with the valid standards, regulations and laws. All safety and warning information and the operating and installation instructions must be complied with.
1. GENERAL INFORMATION 1.1 Appliance Information A damaged appliance can be dangerous. If you find the Faulty components must only be replaced by genuine Linärie appliance is damaged or marked, you must report it within spare parts. The manufacturer can only guarantee the safety 7 days if you wish to claim for damage/marks under the of the appliance when Linärie replacement parts are used.
Ensure that all specified vents, openings and airspaces Tampering with electrical connections or components are not blocked. and mechanical parts is highly dangerous to the user All ducting, pipework and fittings must be of non-flam- and can cause operational faults. Only open the mable material.
Linärie cannot accept liability. Work on electrical components must only be conducted by Please check www.linarie.com.au for more information. trained electrical personnel. 3. DESCRIPTION OF THE FUNCTIONS Non-return flap...
5. INSTALLATION 5.1 Pre-Installation Before installation, it is important to read the information given on Before installing the rangehood, peel off any protective the following pages as well as the "General Safety Instructions" at plastic covering and remove polystyrene from inside the beginning of this booklet.
Page 7
cont .. installation NOTE: 1. Before installation, make sure to switch off the main switch. 2. The ceiling must be able to support a weight of atleast 120kg and the thickness of the ceiling must be equal of greater than 30cm. 3.
Page 8
cont. installation Insert wire rope to rangehood hole as shown. Loosen the cover lock nut Secure it with countersunk screws (ST4x8mm). Insert power cable to rangehood cover plate Slowly loosen adjusting screws and align rangehood and connect to the cables coming out of the ceiling. horizontally.
5.4 Installation [Air Extraction] CAUTION CAUTION Before installation, it is important to read the information given Risk of injury! For safety reasons, only use the size of fastening or on the following pages as well as the "Appliance Dimensions" mounting screw recommended in these operating instructions. and the "Warning and Safety instructions"...
Check the power level selected on the rangehood. A lower power level is generally sufficient for the majority of cooking. Only use the Booster setting when necessary. www.linarie.com.au...
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service center if in any doubt before undertaking any of the above. Always disconnect the unit from the power source when opening the unit. www.linarie.com.au...
8. CLEANING & MAINTENANCE Observe all safety and warning information during operation Allow the appliance to cool down completely before cleaning and (see the “General Safety Instructions” section). maintenance. Before maintenance or cleaning, the rangehood should always The surfaces and controls are susceptible to scratches and be disconnected from the power supply.
Rotate the carbon filter counter-clockwise on both Replacement charcoal filters can be obtained from sides of the motor. Replace the old carbon filters with www.linarie.com.au new carbon filters. Replace the main filters. Disposing of the activated charcoal filter Reconnect the power supply.
When contacting Linärie, please quote the model and invalidated, and Linärie cannot accept liability. serial number of your appliance. These can be found on the data plate, after removing the grease filter. Please check www.linarie.com.au for more information. www.linarie.com.au...
Need help?
Do you have a question about the CALEDONIA RAHID50BG and is the answer not in the manual?
Questions and answers