Table of Contents
Advertisement
Section 3a – OPERATION
The MENU Button allows you to enter the programming and monitoring functions.
Use UP/DOWN ARROW and SELECT to scroll through the Main menu and Sub-menu:
1.0 Test Pool Pilot
2.0 Owner Options
3.0 Maintenance Menu
4.0 Installer Menu
5.0 Exit Menu Mode
The display will automatically cycle through this program, then return to normal operation. The display shows as follows:
1.1 Salt in grams per liter (gm/l) or parts per million (PPM)
1.2 Add Salt indicates the amount of salt needed to add to establish 3.0 gm/l (3000 ppm) based upon pool volume
1.3 Temperature in Celsius or Fahrenheit.
1.4 Cell Volts and Amps
Use UP/DOWN ARROW and SELECT to scroll through the sub-menu. After completing a step, it displays the next step:
2.1 English/Metric: displays volume in gallons or cubic meters; salt additions in lbs or kg; Back – Main Menu (2.0)
2.2 Temperature Units: displays the water temperature in Fahrenheit or Celsius; Back - Main Menu (2.0)
2.3 12/24-hour Time : displays the current time in 12-hour Time or 24-hour Time units; Back – Main Menu (2.0)
2.4 Set Time of Day: sets the time as follows: Set Hours; Set Minutes
2.5 *Pump Program 1: allows you to program the pump on/off cycle through the on-board program
2.6 *Pump Program 2: allows you to program a secondary pump on/off cycle through the on-board program
* Only applicable with Pump Config. (4.6) selection of One-Speed Pump or Two-Speed Pump
* Pump Program 1 or 2 will show the previous time set. Otherwise, Not Programmed will display,
then automatically step to display
Selecting
-Prog steps to Pump ON at Set Hours "12":00 P; Pump ON at Set Mins 12:"00" P
then Pump OFF at Set Hours "12":00 P; Pump OFF at Set Mins 12:"00" P
2.7 Back – Main Menu (returns to MAIN MENU)
Key Features – continued
POOL PILOT
Digital
S a n i t i z e r
12:00P
80F
Boost
Menu
Main Menu
SUB-MENUS
1.0 TEST POOL PILOT
2.0 OWNER OPTIONS
-Prog.
-Delete SELECT-No Change
100%
ON
Check
System
Select
Pump
8
Advertisement
Table of Contents
