CARE AND MAINTENANCE
TROUBLESHOOTING TIPS
RECEIVER/TUNER OPERATION
STEREO indicator is off.
- Adjust the antenna.
- The signal is too weak. Connect an external antenna.
- The signal is Mono.
- Sever hum or noise.
- The signal is too weak. Connect an external antenna.
GENERAL
No audio.
- Make sure the MUTE indicator on the front panel is off.
- Make sure the speakers are turned on.
- Check the connections.
- Check the short plug between PRE OUT jacks and AMP IN
on the rear panel is inserted.
- Check the power cord connection.
No audio from one channel.
- Check the speaker wire connection or connecting cable.
- Check the connection between the receiver and the speaker.
Noise when the TV is turned on.
- T
he TV too close to the unit.
CLEANING THE EXTERIOR
CLEANING THE EXTERIOR
- Disconnect the system from AC power before cleaning the
exterior of the system with a soft dust cloth.
REMOTE CONTROL OPERATION
The remote control does not operate the unit.
- Another function is selected on the remote. Press the correct
function button.
- No batteries installed. Install the batteries before attempting
to operate the remote.
- The batteries are exhausted. Replace all batteries.
- The remote is not pointed at the remote control sensor on the
main unit or there is an obstacle between the remote and the
main unit.
-The remote control is too far from the main unit. Move closer.
NOTE:
Be sure to match the + and - ends of each battery to the symbols
shown in the remote battery compartment.
13