Related Manuals for Sunveytech SWD-MY101V607
Summary of Contents for Sunveytech SWD-MY101V607
- Page 1 WIRELESS BACKUP CAMERA SYSTEM User Manual / Installation Instructions SWD-MY101V607 VEHICLE SAFETY SOLUTIONS Before installation please read the manual...
-
Page 2: What's In The Box
What’s in the Box? NOTE: The contents included may be different based on the kit you purchased. Please take the actual product as standard. 06. Antenna 01. 10.1’’ monitor 07. Manual 02. HD camera 08. Accessories 03. Power Cable 09.Bracket 04. - Page 3 Introduction Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s warranty. Thank you very much for purchasing a Rear View Backup Camera System. With this manual you will be able to properly install and operate the unit.
- Page 4 Monitor Operation onitor Operation Button Function 1)Enter 2)After inserting the card, start/pause recording 3)Long press to bring up the car ruler mode "V/H/M" Switch screen 1) Brightness "-" 2) Enter the menu and select left 3)- 4) Press and hold for 8 seconds to flip the menu 1)Menu 2) Cancel button 3) Long press to zoom X1 X1.5X2 X3 1) Brightness "+"...
- Page 5 On the back of the monitor, you can insert an TF card It is recommended to use high-speed TF card of class 10 or above.(Less than 128G) Plug in the card to start recording(“SEL” to turn on/off recording) Recording: REC Video playback:Close recording -”Menu”...
-
Page 6: Installation Diagram
Installation Diagram Monitor Installation Choose a monitor location in your vehicle that does not block your view and complies with local laws for safe driving. Do not place in an area where it might interfere with driving. Camera Installation Suitable Installation Position... -
Page 7: Connection Method
Connection method Car charger connect to wireless receiver in the monitor “+”ACC/Fuse/radio “+” Taillight “-” Ground “-” Note: Of connecting power directly to battery, the cameras always ON and therefore candrain battery. Therefore it is recommended to connect power to an ignition switched accessory power source. -
Page 8: Pairing The Camera And Monitor
Pairing the Camera and Monitor １ １ NO SIGNAL 1. Select the channel to be pairing 2. Then press "M" ,then select PAIRING CAM1 １ PAIRING START 3. Press the "SEL" confirmation key 4. Waiting for matching and drawing successfully to check the code NOTE: when you need pairing,please confirm the circuit is properly connected and powered.If you need to pairing multiple... -
Page 9: Specifications
Specifications Power Supply DC12 to 36V Wireless Frequency 2.4 GHz 2.4G Wireless network range 2406-2478MHz Wireless Range 300m(open area) Delaying Time <200ms Operating temperature -20°C ~ 80°C CAMERA Image Sensor 1/3 inch Waterproof Rating IP68 View Angle 105°[H] 130°[D] Camera Pixel 1000TVL MONITOR LCD Size... -
Page 10: Troubleshooting
Troubleshooting Problem Solution Check the cigarette lighter has 12-36V DC Output Monitor Won’t turn on Check the fuse in the Cigarette socket adapter Check if the camera is receiving power Camera and Monitor won’t pair Make sure to follow the instructions to operate the Pairing Check if the camera and monitor antennas are installed Distance between camera and monitor is too great. - Page 11 ‐‐ ‐‐ ‐‐ ‐‐...
Need help?
Do you have a question about the SWD-MY101V607 and is the answer not in the manual?
Questions and answers