Advertisement
1
Connect the RV50 cable to the AGI 4 via
the adapter cable and black connector on
the back of the receiver
2
Navigate to the Wrench icon, then
System, then GPS, then Correction;
configure the GPS correction source page
to match the screenshot:
3
Return to the Run screen to confirm RTK
fix as in the screenshot:
MD5007
Quick Reference Card
AGCO C3000 & TopCon X30 & RV50
AGCO C3000 Display Setup
rev 4
DigiFarm
DigiFarm Technical Support
319.531.7574
support@digifarm.com
Advertisement
Table of Contents
Related Manuals for DigiFarm AGCO C3000
Summary of Contents for DigiFarm AGCO C3000
- Page 1 DigiFarm Quick Reference Card AGCO C3000 & TopCon X30 & RV50 AGCO C3000 Display Setup Connect the RV50 cable to the AGI 4 via the adapter cable and black connector on the back of the receiver Navigate to the Wrench icon, then System, then GPS, then Correction;...
- Page 2 DigiFarm Quick Reference Card AGCO C3000 & TopCon X30 & RV50 *Note- If this unit was ordered with a subscription, it will be preprogrammed and plug and play ready. The following instructions will not be needed. Log into the device via WAN static IP (166.XXX.XXX.XXX:8080) or LAN connection (192.168.1.1:8080) on Port 8080.
Need help?
Do you have a question about the AGCO C3000 and is the answer not in the manual?
Questions and answers