Related Manuals for STRIVR Pico G2
Summary of Contents for STRIVR Pico G2
- Page 1 User manual Immersive Learning system for use with Pico G2/G2 4K and Oculus Go v2.0 01/20/2022...
- Page 2 Strivr is a registered trademark of Strivr Labs, Inc. Copyright ©2022 Strivr Labs, Inc. All rights reserved.
-
Page 3: Table Of Contents
Choosing a training space ..................................8 Putting on and adjusting the headset ...............................8 Acclimation screens ....................................9 Logging out ........................................10 Returning the headset .....................................10 The Strivr Portal ........................................11 FAQ & troubleshooting ....................................12 System setup ........................................14 Health & safety warnings ....................................21 Contact us ..........................................22... -
Page 5: Welcome To Immersive Learning
Strivr Portal, where you can view and track training results and analytics. This manual covers use of the Strivr Immersive Learning system with Pico G2 and 4KS, and Oculus Go headsets. Look for special information that applies specifically to Pico or Oculus headsets throughout the manual. -
Page 6: Quick Start
Quick start Quick start Welcome to Immersive Learning with Strivr. Let’s look at quick steps to get up and running: 1. Unbox your gear In each headset box, you’ll find a VR headset with a controller attached by a tether, plus a charge cable, wall adapter, and batteries. -
Page 7: Headset Basics
H E A D S E T L I G H T I N D I C AT O R M E A N I N G S COLOR STATE MEANING Solid Low battery (Pico G2/4KS: less than 15%; Oculus Go: less than 20%) White Solid Screen is on White... -
Page 8: Controller Basics
User manual Controller basics Adjusting the volume Use the volume button on the headset to adjust the sound level. Pico G2/4KS controllers also include a volume control on the right side of the controller Built-in speakers vs. headphones The headset has built-in speakers. These speakers are good for self-guided training or training in small groups. -
Page 9: Product Care & Maintenance
Product care & maintenance Changing controller batteries See Controller Basics. Pico G2/4KS controllers take 2 AAA batteries; Oculus Go controllers take 1 AA battery. After changing controller batteries, you may need to re-sync the controller. NOTE: Be careful not to detach the tether. If you do, open the battery compartment cover and loop it back around the small plastic peg. -
Page 10: Handling The Headset
Do not store in direct sunlight. Most Strivr Immersive Learning systems are stored in trays, lockers, or portable carts that have cutouts for storing each headset. If your system came with plastic bins for storage and transportation of the headsets, place each headset-controller pair inside a section of the bin. -
Page 11: Facilitating Training
Facilitating training Headset wi-fi connection It’s important that headsets are connected to the Strivr cloud to transmit training results and to receive content and system updates. For systems with stand-alone headsets (system does not include a management device), check the connection before each training session and at the end of the day. Systems with management devices connect through those.) -
Page 12: Retrieving The Headset
The learner may then tighten the side straps such that the headset’s display remains secure over their eyes. • Headphones: If using external headphones, instruct learners to put them around their neck first, then, after putting on and adjusting the headset, lift the headphones over their ears. support.strivr.com... -
Page 13: Acclimation Screens
When learners first put on the headset, they see several screens that tell them how to use the controller, choose right or left hand control, adjust the headset, and log in to Strivr training. NOTE: The screens learners see at your company may not match these screens exactly. -
Page 14: Logging Out
Disconnect the headset, hold the headset power button down for 5 seconds or until the blue indicator light illuminates, and then reconnect it. When a headset is powered on, holding the headset up to your eyes causes the screen inside to illuminate. support.strivr.com... -
Page 15: The Strivr Portal
User manual The Strivr portal The Strivr Portal If you have access, you can visit the Strivr Portal at https://portal.strivr.com to: • View and analyze training results including usage, score, and more • Check to see if headsets are properly connected •... -
Page 16: Faq & Troubleshooting
Pico G2/4KS and Oculus Go: If you’re having trouble • Hold the power button on the headset for using the controller, try one of the following: about 5 seconds, or until the blue indicator •... - Page 17 User Manual FAQs & troubleshooting Why is everything gray in the headset? 2. If your system includes Pico G2 or 4KS headsets and a management device, the headsets should • Be sure to look all around in the 360-degree turn on automatically when plugged in to charge.
-
Page 18: System Setup
If your system contains stand-alone headsets and a USB hub for charging, first set up the USB hub, then plug in and charge. Strivr provides a USB hub to simplify charging for implementations with more than one headset in a single storage solution. - Page 19 User manual System setup 3. Locate the USB cables. There will be one per headset. Plug each USB cable into the USB hub (up to 5 per USB hub): PICO G2/4KS USB TO USB-C OCULUS GO USB TO MICRO-USB Headsets with USB hub and management device If your system contains headsets, a USB hub, and a Management Device (a mini-computer that handles uploads and downloads of content and system updates), you’ll first set up the management device, then connect it to...
- Page 20 3. Locate the box containing the USB hub. Unbox the USB hub and the accessories with it (if you have a system with more than 5 headsets, your USB-to-SS cable may be blue): USB HUB USB-TO-SS POWER BRICK IEC CABLE CABLE support.strivr.com...
- Page 21 Plug the USB end of the USB-to-SS cable into USB port 1 on the front of the MD (the top left port). USB PORT 1 5. Plug the SS end of the USB-to-SS cable into the SS port on the USB hub. SS PORT support.strivr.com...
- Page 22 OCULUS GO USB TO USB-C USB TO MICRO-USB If your system has 3 or more headsets, Strivr provides a Wireless USB Adapter that will be inserted into the USB hub to improve signal strength. a. Locate the box containing the Wireless USB Adapter.
- Page 23 Locate the USB cables that came with your headsets. There will be one per headset. Plug each USB cable (up to 5 per USB hub) into the USB hub starting at Port 2. PICO G2/4KS USB TO USB-C OCULUS GO USB TO MICRO-USB support.strivr.com...
- Page 24 MANAGEMENT DEVICE b. A green light on the LTE modem indicates when it is connected. The light flashes green while it is searching and connecting. Ethernet cable Connect the ethernet cable to the Management Device. ETHERNET CABLE MANAGEMENT DEVICE support.strivr.com...
-
Page 25: Health & Safety Warnings
MAY EXACERBATE YOUR CONDITION. other implanted electrical devices. If you have a pacemaker or other implanted medical device, DO NOT USE STRIVR PHOTOSENSITIVITY & SEIZURES WITHOUT FIRST CONSULTING YOUR DOCTOR OR THE MANUFACTURER OF YOUR MEDICAL DEVICE. Maintain... -
Page 26: Contact Us
If you have a history of any physical or psychological problems triggered by experiencing scary, violent, or anxiety-inducing images or videos, avoid viewing the triggering content or do not use the VR headset. Contact us Strivr Support: https://support.strivr.com US & Canada: +1 855-897-0082 UK: +44 808-169-4550 support@strivr.com... - Page 28 www.strivr.com...
Need help?
Do you have a question about the Pico G2 and is the answer not in the manual?
Questions and answers