Richmat HJC56 Ble Manual

Richmat HJC56 Ble Manual

Control box

Advertisement

Quick Links

Control box
HJC56 Ble

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HJC56 Ble and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Richmat HJC56 Ble

  • Page 1 Control box HJC56 Ble...
  • Page 2 1. Remark: Up to 4 motors BLE control available Memory function Color: black 2. Dimension:(mm) 3.System configuration diagram Before powering on, please install the accessories in place according to the system configuration diagram...
  • Page 3 4.Remote control button silicone diagram 5.Fixed position size LOUNGE SNORE Head(mm) Foot(mm) 6.Remote control function description Button Function label Press the button, the motor will run to the TV position with one button (there is an initial position) Multiplexing function: Press and hold the FLAT button while pressing the TV button, the buzzer sounds, the backlight flashes, and the current motor status is recorded to the TV position.
  • Page 4 with one button (there is an initial position) Alternate function: Press and hold the FLAT button while pressing the ZG button, the buzzer sounds, the backlight flashes, and the current motor status is recorded to the ZG position. (Power-off memory clear) Press the button to extend the back motor, and the back motor extends to the position of maximum stroke to stop.
  • Page 5 Multiplexing function: press the button, if the head massage motor is not activated, it will start the head massage motor and enter the "CONSTANT" mode, if the head massage motor is activated, the vibration intensity of the head massage motor will be enhanced, a total of 3 intensities, When the intensity increases to the maximum, press the button to turn off the massager.
  • Page 6 Caution: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Table of Contents