Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Richmat HJC26C Ble
Summary of Contents for Richmat HJC26C Ble
- Page 1 Control box HJC26C Ble...
- Page 2 1.Remark: Up to 2 motors BLE control available Memory function Color: black 2.Dimension:...
- Page 3 3.System configuration diagram 4.Remote control button silicone diagram...
- Page 4 5.Remote control function description Button function label ANTISORE (anti-screaming): Tap to run to the leisure position (there is an initial position). The customer cannot modify the location. ZG (Zero Gravity): Tap to run to zero gravity position. (With initial position) Multiplexing function: FLAT+ZG for about 3s, the backlight of the remote control flashes, the buzzer of the control box sounds "dididi", and the current position is memorized as the ZG (zero gravity)
- Page 5 Press the button, the leg motor retracts, release it to stop. One-button reset: press the button, the massager is turned off, and the motor retracts to the FLAT position at the same time. (Not reset after power on) Short press the button: If the back massage motor is not activated, it will start the back massage motor and enter the first-level intensity "CONSTANT"...
- Page 6 Caution: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the HJC26C Ble and is the answer not in the manual?
Questions and answers
The small, rectangular window on our HJC126 is not lit. Remote batteries are new and the power light on the module is lit. I’m assuming that the other rectangular light indicates the electronics on the module indicates whether or not the module can connect with the remote. If so, then I would think that the control unit would require replacement. If that is so, then I would need the information in order to purchase a new control unit. Thank you.
Ever since we purchased our lift bed. When I put the head up, the motor runs for a few seconds before activating the lift. Is there a way to adjust the down stop point of the motor/lift? If possible I’d like the lift to start as soon as the motor starts. The motor. For the head is “NL200.