Operation; Starting & Stopping; Using The Blower - FERREX 705158 User Manual

1100 W Turbine Blower

Operation

1. Starting & stopping (See Fig. F)
- Starting
Move the on/off switch (4) to the "I" or "II" On
position.
Speed "I" is the lower speed. Speed "II" is higher
speed.
- Stopping
Move the on/off switch (4) to the "0" Off position.
WARNING! The blower runs for a few seconds after it has been
switched off.
NOTE:
Let the motor come to a complete standstill before setting the
blower down.

2. Using the blower

WARNING: During operation of the blower it is recommended to
wear eye protection, a dust mask, and full hearing protection.
Ensure you are wearing suitable clothing.
User tips
- Adjust the blowing speed (I or II) according to the desired working
condition.
- Hold the blow tube approximately 8" (20.3cm) above the ground when
operating the blower.
- Use a sweeping motion from side to side. Advance slowly keeping the
accumulated debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it is easy to dispose of the
pile.
AFTER SALES SUPPORT
1300 889 028
(toll free)
F
e-mail: info.aldi@positecgroup.com
MODEL No.: GBV100W • 03/2022 • 705158
12