Table of Contents
Advertisement
Available languages
Available languages
D – OPERATION INFORMATION
Figure 1
A: ON – OFF SWITCH
B: RED LED
C: GREEN LED
D: TEMPERATURE BUTTON
- Usage:
The first time the device is used, the temperature setting is max. and run it idle for 30
minutes. Some odor and smoke may occur due to the insulating coating material during
operation. It will then disappear.
When you turn on the device, see that the red and green LED lights on the front are on. The
red LED will turn off when the desired temperature is reached. However, it is not sufficient
for homogeneous heating of the entire cooking area. For this, preheat the device for a
homogeneous heat distribution between 30 – 45 minutes by adjusting the heat setting to the
desired level each time it is used for the first time. Then proceed to the cooking process.
Make sure the potatoes that will be baked are clean and not wet. Place carefully the
potatoes in the lidded drawers without exceeding the capacity so that they won't cramped
together. You can put the baked potatoes in the compartment at the top of the oven to keep
them from cooling.
Since the device is thermostat adjusted, when the temperature exceeds the maximum
degree, the limiter will be activated and cut off the heat. In this case, you can see that the
green LED light turns off. Press the limiter reset button on the back of the device and see
that the green LED light is on for re-engage the thermostat. In this way, the device will reach
the desired temperature again.
Always use gloves while using the device.
23
Advertisement
Table of Contents
